Table of Contents
Advertisement
S
Z
ELECTING A
ONE AND
Select the desired zone using the GRP
group of channels.
Select the desired channel using the CH control. Each channel is programmed
with settings for transmitting and receiving.
• If programmed by your dealer, the transceiver will announce the zone and channel
numbers as you change them.
Names can be programmed for zones and personalities. Your dealer can set the
will shorten appropriately. (KCH-14 models display only 12 digits). For example,
if the channel name is "–CHANNEL1–" and the zone name is "KENWOOD", and
your dealer sets the zone name to 4-digits, the following display will appear:
KCH-14 (12-digit display):
KCH-15 (14-digit display):
T
RANSMITTING
For Trunking channels, refer to "Making Group Calls" and "Making Individual
Calls" on the following page.
1 Select the desired zone and channel using the GRP
CH control.
2 Press (or press and hold) the key programmed as Monitor or Squelch Off to
check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch to receive.
• The TX indicator lights red while transmitting. The BUSY indicator lights green while
receiving a signal. This indicator can be disabled by your dealer.
• For best sound quality at the receiving station, hold the microphone approximately
1.5 inches (3 ~ 4 cm) from your mouth.
12
C
HANNEL
KENW–CHANNEL
KENW–CHANNEL1–
and
keys. Each zone contains a
and
keys and the
Advertisement
Table of Contents
