Ping Ipv4/Ipv6; List - Platinum Tools Net Prowler TNP800 User Manual

Ping IPV4/IPV6

The default Ping is set to IPV4. To change to IPV6, press the IPV6 soft key.
y Connect the Net Prowler to a switch, router, or active network jack.
y From the home screen, press the right arrow button to select the
Network Discovery icon and press the enter button or press
the Network Discovery soft key
y The Net Prowler will display DHCP test information upon entering
the IPV4 Device Discovery screen.
y Press the IPV6 soft key to ping IPV6
y Press the ping soft key
y Use the left and right arrows to highlight a digit. To change a digit,
use the up and down arrows or press the keypad soft key
to use an alphanumeric keypad. To unselect the keypad, press the
keypad soft key again.
y Press the Test button to ping the IP address.
y The Net Prowler will display the Response IP, device name (if
available), and response time in milliseconds.
.
.
.
14

List

The Net Prowler will automatically add an IP address to the List after it has
been pinged. If a Network Mapping test has been performed, the discovered
IP addresses will also be added to the list (see Network Mapping pg. 16).
y From the Ping screen
to view discovered IP addresses and manually pinged IP addresses.
y To ping an IP address in the List, use the up and down buttons to
navigate to the desired IP address and press the test button
y To ping IP addresses stored as Favorites, press the Favorites
soft key .
y Use the up and down arrow buttons to scroll to the desired IP address.
y Press the Test button
test button again to ping the selected IP.
, press the List soft key
to select an IP address then press the
15
.