Changing A Setting - Platinum Tools Cable Prowler TCB400 User Manual

Changing a Setting

▪ RJ45 VoP
▪ Coaxial VoP
cable.
▪ TIA568A/TIA568B: Set the RJ45 wiring configuration graphic to
display TIA568A or TIA568B wiring standard.
▪ Pair/Pin: Set the RJ45 wiremap to measure by pair or pin.
▪ Meters/Feet
Meters or Feet.
▪ Pair/Pin can be changed to test the RJ45 from Wire Order to Pair
Order.
▪ Power Off Timeout
00.5-99.9 minutes.
▪ LCD Dimmer Timeout
from 00.5-99.9 minutes.
▪ Language: Set the desired language from English (default) to
Spanish, Italian, German, or French.
▪ Tone Generator Timeout: Set the desired automatic timeout 00.5-
99.9 minutes.
▪ PoE Test: Turn the PoE test On or Off. Turning the PoE off will allow
the Cable Prowler to detect a network without running a PoE test.
▪ Press the "Calibrate" softkey to calibrate the Cable Prowler. This will
calibrate the Cable Prowler at 0 ft. No cables should be connected
to the Cable Prowler when performing a calibration.
▪ Press the Save soft key to save your options.
Note: If only temporary change is desired, do not press the save
button. If the save button is not pressed, the previous settings
will be restored once the unit is powered off.
▪ To restore factory default values, press the defaults soft key.
▪ To view saved files, press the Files soft key.
: Set the VoP to be used to measure RJ45 cable.
: Set the VoP to be used to measure coaxial
: Set the length measurement to be displayed in
: Set the desired automatic timeout from
: Set the desired automatic timeout
11