Troubleshooting - Philips Azur GC4250/12 Manual

ENGLISH
12
Problem
The iron is plugged in but the
soleplate is cold.
The iron does not produce any
steam.
The (vertical) shot-of-steam function
does not work.
Water droplets drip onto the fabric.
Flakes and impurities come out of
the soleplate during ironing.
The blue alert light blinks, 'OFF'
blinks and the iron beeps.
The iron is plugged in but the blue
alert light is out.

Troubleshooting

This chapter summarises the most common problems you could
encounter with your iron. Please read the different sections for more
details. If you are unable to solve the problem, please contact the
Customer Care Centre in your country.
Possible cause(s)
There is a connection problem.
There is not enough water in the
water tank.
The steam control has been set to
position 0.
The iron is not hot enough.
The (vertical) shot-of-steam function
has been used too often within a very
short period.
The iron is not hot enough and/or the
drip-stop function has been activated.
The cap of the filling opening has not
been closed properly.
An additive has been poured into the
water tank.
You have been using hard water,
which has caused scale flakes to
develop inside the soleplate.
The safety shut-off function has
switched the iron off (see 'Safety
shut-off function').
There is a connection problem.
Solution
Check the mains cord, the plug and the
wall socket.
Fill the water tank (see 'Filling the water
tank').
Set the steam control to a position
between 1 and 6 (see 'Steam ironing').
Select an ironing temperature that is
suitable for steam ironing (2 to
MAX). Put the iron on its heel and wait
until the amber pilot light has gone out
before you start ironing.
Continue ironing in horizontal position
and wait for a while before using the
(vertical) shot-of-steam function again.
Select an ironing temperature that is
suitable for steam ironing (2 to
MAX). Put the iron on its heel and wait
until the amber pilot light has gone out
before you start ironing.
Close the cap properly.You will hear a
click.
Rinse the water tank and do not put
any additive in the water tank.
Use the calc-clean function a few times
(see 'Using the calc-clean function').
Move the iron slightly to deactivate the
safety shut-off function.The iron stops
beeping and starts heating up again.
Check the mains cord, the plug and the
wall socket.