Mounting Of Handle; Mounting Attachment - Makita EX2650LHM Instruction Manual

MOUNTING OF HANDLE

CAUTION: Before doing any work on the Multi Function Power Head, always
stop the engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Multi Function Power Head only after having assembled it
completely.
Assembling loop handle
(For tools with a barrier)
- Fix a barrier to the left side of the machine together with the handle for
operator protection.
- Do not adjust position of the loop handle too close to the control grip. Keep
not less than 250 mm distance between the handle and the grip.
(a distance collar is provided for this purpose.)
- Never install the loop handle on the label or the joint.
(For tools without a barrier)
- Fix the handle on the drive shaft.
Do not adjust position of the loop handle too close to the control grip. Keep
not less than 250 mm distance between the handle and the grip.
(a distance collar is provided for this purpose.)
- Never install the loop handle on the label or the joint.

MOUNTING ATTACHMENT

CAUTION: Before doing any work on the Multi Function Power Head, always
stop the engine and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the Multi Function Power Head only after having assembled it
completely.
Assembly
- Loosen lever.
- Align the attachment's pin with the joint's groove and insert pin.
- Insert attachment up to the arrow position of attachment.
And, check to see that button has risen.
- Tighten lever.
(See diagram on right for guideline.)
9
Engine
Joint