Front Handle - Makita SG1250 Instruction Manual

Adjusting the groove width (the distance between
the two diamond wheels)
The width of grooving in the workpiece can be adjusted
by changing the number of the space rings as shown in
the table.
Groove width: 30 mm
1
4
Groove width: 24 mm
Groove width: 18 mm
Groove width: 12 mm
Groove width: 6 mm
1. Lock nut
2. Diamond wheel
3. Space ring 6 (6 mm thick)
4. Space ring 3 (3 mm thick)
5. Diamond wheel
004503
INSTALLATION
1
004504
Determine the distance of the two blades according to
the table.
Groove width: 27 mm
2
3
5
Groove width: 21 mm
Groove width: 15 mm
Groove width: 9 mm
1. Diamond wheel
2
2. Blade case
To install the diamond wheel, mount it carefully onto the
spindle, making sure that the direction of the arrow on
the surface of the diamond wheel matches the direction
of the arrow on the tool. Install space ring and lock nut.
Tighten the lock nut securely clockwise with the lock nut
wrench while pushing down the shaft lock.
Return the cover and the base to the original position
and tighten the bolt to secure them.

Front handle

1
2
004505
1. The angle of installation of the front handle is
changeable.
To change its position, loosen the two bolts on both
•
sides of the front handle with the hex wrench and
move the front handle to your desired position.
NOTE:
When the handle cannot be moved easily, loosen
•
the bolts furthermore.
To secure the handle, tighten the two bolts firmly.
•
2. The front handle can be shifted sideways.
2
1
1. Hex socket head bolt
2. Cam
3. Hex socket head bolt
4. Hex socket head bolt
5. Cam
6. Hex socket head bolt
004506
To shift it, loosen and remove the two bolts on both
•
sides of the front handle.
Remove the cam and install it on the opposite side
•
as shown in the figure.
Insert the longer bolt to the hole in the handle on
•
the side close to the installed cam and the shorter
bolt on the opposite side.
Then tighten the two bolts firmly.
•
8
1. Front handle
2. Hex socket
head bolt
3 4
5 6