Clock; Set Radio Signal Format; Sensor Data Transmission; Sensor Search - Oregon Scientific BAR998HGN Manual

CLOCK

This remote sensor can automatically synchronize the date
and time with official time-keeping organizations in
Frankfurt (Germany) and Rugby (England). When the
sensor is within 1500 km (932 miles) of a RF signal, the
reception icon will blink during reception.
When the sensor receives the radio-controlled clock signal
and is paired with the main unit, the clock in the main unit
will be automatically updated.

SET RADIO SIGNAL FORMAT

The RADIO SIGNAL FORMAT switch is located inside
the battery compartment. Select EU (DCF) or UK (MSF).
Then, press RESET.
Reception takes 2 – 10 minutes to complete. Once
complete, the icon will stop blinking.
STRONG SIGNAL
To force a manual RF clock reception, press and hold
SEARCH for 2 seconds.
WEAK OR NO SIGNAL
OR

SENSOR DATA TRANSMISSION

Data is sent from the sensor(s) every 60 seconds. The
reception icon shown in the Temperature / Heat Index Area
indicates the status.
ICON
--- shows in Temp /
Humidity Areas

SENSOR SEARCH

To search for a Thermo / Hygro sensor, press SELECT to
navigate to the Temperature/ Heat Index Area.
in the lower right corner of the Area. Then, simultaneously
press and hold MEMORY and CHANNEL for 2 seconds.
To search for the UV sensor, press SELECT to navigate
to the UVI / Barometric Trend Area.
lower left corner of the Area. Then, press and hold
MEMORY and CHANNEL for 2 seconds.
NOTE
If the sensor is still not found, check the batteries.
8
DESCRIPTION
Main unit is
searching
for sensors.
At least 1 channel
has been found.
Sensor 1 is sending
data. (The number
shows which sensor
is selected.)
The selected sensor
cannot be found.
Search for the sensor
or check batteries.
will show
will show in the