Using The Undok App - Sangean Fusion WFR-30 Manual

Using the UNDOK app

1. Download the UNDOK app
Download and install the UNDOK app to your Android or iOS device from the Android Google
Play store or Apple iTunes App store.
● Make sure the UNDOK app installed on your device has the latest version.
● T he app may update a new version on the internet from time to time, so this app may have
been changed slightly since these instructions were written.
Note: The images used below extract from Android device. If your device uses iOS Apple or
different UNDOK version, the display may be slightly different.
2. Start UNDOK app, making sure your radio and smartphone are connected to the same WiFi
network.
3. The device will be listed on the screen. Tap your radio, for example "WFR-30 xxxxxxxxxxxx"
(the 12 digit alphanumeric code is the MAC address of your radio) to establish a connection
between UNDOK and your radio.
4. I f no device shown on the display, tap the 'Set up Audio System' on the bottom left corner to
help configure your device to your WiFi network.The UNDOK app has a setup wizard to help
configure suitable audio devices to connect to your WiFi network.
5. The app will show a list of suggested audio systems to setup. Your radio will normally appear
in this list as "WFR-30 xxxxxxxxxxxx". It may appear in the list below called Other. Select the
audio system to be setup.
6. Use the app to complete the audio system setup, including giving the audio system a name if
needed.
7. S elect the preferred method to connect your audio system to the network (E.g WiFi).
8. For a WiFi connection the app will ask you to choose a WiFi network and enter the appropriate
password. Your audio system will connect to your network.
Note:
If when setting up your audio system your Android device complains that it cannot connect to
the internet this is because it is temporarily connected directly to your audio system. You should
ignore this warning message.
16
Cancel OK
Done Done