Sangean Fusion WFR-30 Manual page 14

5. I n most installations the DNS settings (DNS = Domain Name Server) will be set to the same IP
address as your router. In this case the secondary DNS may be left at zero. To enter the DNS
address, rotate the Tuning Control Rotary to set the value for each group of digits and then
press the Tuning Control Rotary to enter the value and to move on to the next group. Repeat
this until all eight groups of digits have been entered.
6. The next step is to set up the WiFi connection, starting with the name of the wireless network
(SSID) followed by the encryption options and password. To enter the SSID, characters are
selected and entered using the Tuning Control Rotary The radio scrolls through the available
characters as well as the three controls on the right. The character currently highlighted will
be entered when you press the Tuning Control Rotary. Do this as needed until the complete
network name has been entered. The SSID setting is sensitive to upper and lower case
characters and symbols.
You must enter it exactly as set up in your router. The three controls on the right-hand side of
the screen have special functions:
select ' ' to erase a character just entered
select ' ' when the complete SSID has been entered
select ' ' to cancel and go back to the DNS settings screen
7. H aving entered the SSID, you must enter details of the encryption system used on your
wireless network. This should be the same as specified in your router settings. If your network
does not use encryption, then select the 'Open' option. Your radio should then connect to the
network, so skip to step 11. If your network uses WEP (Wired Equivalent Privacy) select the
'WEP' option then go to step 8. The remaining options are for WPA or WPA2 (WiFi Protected
Access) – see step 9.
8. I f you chose 'WEP' in step 7, you will then enter the 'PreSharedKey' option. The key should
be entered using only the numbers 0-9 and the letters A-F. The key will be 10 characters long
for 64-bit encryption and 26 characters long for 128-bit encryption. The radio will accept lower-
case letters a-f as equivalent to upper-case A-F. Spaces or special symbols are not permitted
in WEP keys.
The three controls on the right-hand side of the screen have special functions:
select ' ' to erase a character just entered (long press to clear); Info again to continue
select ' ' when the complete encryption key has been entered
select ' ' to cancel and go back to the SSID settings screen
Once the key is entered the radio should connect to your network. Please skip to step 11.
DNS 5/9
Primary DNS
192 168 1 1
Secondary DNS
0 0 0 0
SSID 6/9
Authentication 7/9
Open
WEP
WPA/WPA2
Encryption type 8/9
PreSharedKey
GB
13