Basic Shooting Operations; Preparing For Recording; Sd Memory Card Access Lamp - Panasonic AG-HMC80P Operating Instructions Manual

Basic shooting operations

Preparing for recording

1
Set the camera's power switch to OFF.
(Page 30)
• Check that the mode lamp is off.
2
Slide the card cover upwards to open.
ACCESS lamp
· Flashes during SD
Memory Card access
(recognition, recording,
playback, deletion, etc.).
For details, see "SD
Memory Card ACCESS
lamp".
3
Fully insert an SD Memory Card into the
card slot.
• Insert the card in the direction shown until it
clicks into place.
4
Close the SD Memory Card cover.
• Ensure that the cover firmly clicks into place.
36
•
Performing these operations may damage the
SD Memory Card or its contents, or cause the
camera to fail to operate correctly.
Opening the card door and removing the SD
Memory Card
Switching off the power
Removing the battery
Connecting or disconnecting the USB
connection cable
Shaking or striking the camera
• Always format SD Memory Cards that have
been used in other devices when first using
them with this camera. (Pages 28, 76 of Vol.2)
• If "CHECK CARD" is displayed on the
viewfinder, please remove the SD Memory
Card and insert it again.
This lamp lights or flashes during memory card
access.
Lit: Card inserted, read/write possible
Flashing (fast): Recognizing
Flashing (slow): Accessing (during recording/
playback/reading)
Off: Card not inserted, unformatted card inserted,
write protected card inserted

SD Memory Card access lamp