Indicator Of Program Sequence; Selecting A Different Program; Cancel Program; Program End - Bosch WTG865H2UC/01 Use And Care Manual / Installation Instructions

Indicator of program sequence

Bosch dryers use an advanced control system which
continually monitors the laundry's remaining moisture.
The current state of the process and status of the
program is shown by indicator lights and 7-digit display.

Selecting a different program

If you have inadvertently started the wrong program, you
can change this as follows:
Press Start/Pause.
1.
NOTICE: The drum will continue to rotate when the
Cool Down process is in progress, even if the program
is paused. The Cool Down process can be stopped at
any time by opening the door.
Select another program and/or a different optional
2.
program setting.
NOTICE: Do not change the program during the Cool
Down process.
Press Start/Pause. The new drying cycle starts from
3.
the beginning.

Cancel program

If required, you can cancel the selected program:
Press Start/Pause.
1.
Press the center of the Program Selector to switch off
2.
the appliance.

Program end

- appears in the display area and the Start/Pause
- ‹
button indicator lamp is off.
After the program end, press the center of Program
Selector to switch off the appliance.
Removing laundry/switching the
appliance off
Open the door and remove the laundry.
1.
Press the center of the Program Selector. Appliance is
2.
switched off and dryer light goes out.
Clean lint filter.
3.
~ Cleaning the lint filter; Page 38
Close the door.
4.
Tip: If the display panel switches off and the Start/Pause
button indicator is blinking at the end of a program, the
Energy-saving mode is active. To activate the display,
press any button.
~ Environmentally friendly use of your dryer; Page 9
29