Leveling The Dryer; Check Heating System - Bosch WTG865H2UC/01 Use And Care Manual / Installation Instructions

Table of Contents

Advertisement

Reinstall the connection box cover making sure all
14.
wires are routed so they do not touch any part of the
enclosure and are secure.
Reinstall the appliance top cover as previously
15.
described in "2" above.
Integrated electrical receptacle
This appliance is equipped with a 208/240V 15A
receptacle for use ONLY with Bosch washer.
CAUTION
9
Do not use this receptacle to power any other
device.
If any other electrical device is plugged into this
receptacle Bosch assumes no liability.
CAUTION
9
Use integrated electrical receptacle only for 208/
240V Bosch washers.

Leveling the dryer

Importance of leveling the dryer
It is important that your dryer is level and that all four
dryer feet press with equal pressure against the floor.
This will help assure the quietest, most vibration-free use
of your dryer.
To adjust the dryer feet:
Install the dryer on a level and solid surface, preferably
1.
in a corner of a room.
If the floor is uneven (or not level) adjust the dryer feet
2.
as required to level the dryer. Do not place anything
under the dryer feet to help level the dryer.
Extend the dryer feet no more than is necessary. The
3.
more the feet are extended, the more vibration the
dryer will experience. Start with the dryer feet turned all
the way in and adjust each foot as necessary.
Use a bubble level to check the top of the dryer to
4.
make sure it is level side to side and front to rear.
Press down on each corner of the dryer top to make
5.
sure the dryer does not "wobble". There should be no
"give" or movement. All four dryer feet should press
equally against the floor. This is just as important as
the dryer being level to prevent vibration.

Check heating system

Check that the drum is empty.
1.
Close the dryer door.
2.
Switch the dryer to the Cotton program and select
3.
Extra Dry dryness level.
Press the Start/Pause button.
4.
After 2-3 minutes press the Start/Pause button and
5.
open the door.
If the interior of the dryer feels warm, the dryer has
been connected properly. Press the center of the
Program Selector to switch off the appliance.
If the dryer does not work, press the center of the
Program Selector to switch off the appliance. Look
in the Troubleshooting section of this user manual
for hints in solving the problem.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wtg865h2ucWtg865h2

Table of Contents