Table of Contents
Advertisement
Alternate Grounding Methode: Neutral wire of 3-wire
13.
cord (usually white or middle conductor) can be
connected directly to PE as shown below.
WARNING
9
ELECTRIC SHOCK HAZARD
BEFORE plugging power cord into the
receptacle, the continuity between the Neutral
(center) pin of the power cord and the metal
frame of the appliance MUST be confirmed by
use of a self-energized circuit tester.
Tighten the strain relief screw ensuring the power cord
14.
cannot be pulled out of the connection box but not so
tight as to cut the power cord insulation.
Reinstall the connection box cover making sure all
15.
wires are routed so they do not touch any part of the
enclosure and are secure.
Reinstall the appliance top cover as previously
16.
described in "2" above.
Integrated electrical receptacle
This appliance is equipped with a 208/240V 15A
receptacle for use ONLY with Bosch® washer.
CAUTION
9
Do not use this receptacle to power any other
device.
If any other electrical device is plugged into this
receptacle Bosch® assumes no liability or responsibility.
CAUTION
9
Use integrated electrical receptacle only for 208/
240V Bosch® washers.
Leveling the dryer
Importance of leveling the dryer
It is important that your dryer is level and that all four
dryer feet press with equal pressure against the floor.
This will help assure the quietest, most vibration-free use
of your dryer.
To adjust the dryer feet:
Install the dryer on a level and solid surface, preferably
1.
in a corner of a room.
If the floor is uneven (or not level) adjust the dryer feet
2.
as required to level the dryer. Do not place anything
under the dryer feet to help level the dryer.
Extend the dryer feet no more than is necessary. The
3.
more the feet are extended, the more vibration the
dryer will experience. Start with the dryer feet turned all
the way in and adjust each foot as necessary.
Use a bubble level to check the top of the dryer to
4.
make sure it is level side to side and front to rear.
Press down on each corner of the dryer top to make
5.
sure the dryer does not "wobble". There should be no
"give" or movement. All four dryer feet should press
equally against the floor. This is just as important as
the dryer being level to prevent vibration.
19
Advertisement
Table of Contents
