Belkin F1DC108V User Manual page 18

INSTALLATION
SECTIONS
Table of Contents
Connecting the Primary and Secondary KVM Switches:
Step 1
Using the Daisy-Chain Cable (F1D108-CBL), connect one end to the
"Daisy-Chain In" port on the Rack-Mount Console (BANK 00).
Step 2
Connect the other end of the Daisy-Chain Cable (F1D108-CBL) to the
"Daisy-Chain Out" port of the first secondary KVM switch (BANK 01).
Step 3
To add secondary units, connect one end of the Daisy-Chain Cable
(F1D108-CBL) to the "Daisy-Chain In" port on the first secondary KVM
switch and the other end to the "Daisy-Chain Out" port of the next
secondary KVM switch (for example, BANK 01).
Step 4
Repeat Step 3 for additional PRO3 KVM Switches you wish to
daisy-chain together.
18.5" Widescreen Rack-Mount Console with Built-In PRO3 KVM Switch
1 2 3 4 5
Connecting the Servers:
Step 1:
Connect all servers to the primary and secondary KVM switches. Refer to
the "Connecting Servers to the Rack-Mount Console" section on page 9
for instructions.
Step 2:
Power up the secondary KVM switches sequentially, beginning with the
highest BANK, by connecting each unit's power supply. Each KVM switch
should display its corresponding BANK-address number as it is powered up.
Step 3:
Verify that the primary KVM switch has detected all secondary KVM
switches by scrolling through the BANKs by using the OSD.
16
6 7 8