Advertisement
TROUBLESHOOTING
Before calling for service, please review the list below, since the problem may not be the product malfunction.
Odor and smoke persists.
• Check the filters. If they appear to be extremely
dirty, clean or replace them.
• Check if the plastic bag is removed from the filter.
(Page 8)
The Cleanliness Monitor is blue
even when the air is not clean.
• The air may have been dirty when the main unit
was plugged in. Unplug the main unit, wait one
minute, and then plug the main unit in again.
The Cleanliness Monitor light is
red even when the air is clean.
• Dirty or clogged dust(sensitive) sensor openings
interfere with sensor operation. Gently clean the
sensor filter or the back panel.
The Main Unit makes a clicking or
ticking sound.
• The main unit may make clicking or ticking
sounds when it is generating ions.
Air discharged from the Main Unit
has an odor.
• Check to see if the filters are extremely dirty.
• Clean or replace the filters.
The Main Unit does not operate
when cigarette smoke is in the air.
• Make sure the Main Unit is installed in a location
in which the sensors can detect cigarette smoke.
• Check to see if the dust(sensitive) sensor
openings are blocked or clogged. If they are
blocked or clogged, clean the sensor filter or the
back panel.
Smell from a new unit and/or filter.
• Immediately after removing the plastic bag, a
slight odor may occur. This odor is not harmful for
filter performance or human exposure.
The FILTER Replacement Indicator
Light is flashing.
• Whenever after performing replacing the filters,
connect the power cord to an outlet and then
press the Filter Reset Button. (Page 5)
FX-J80J_2nd.indd
FX-J80J_2nd.indd
12
12
The Front Display is turned off.
• When Light control is set to "Auto", the light
automatically turns off when the room is dark.
Moreover, when Light control is set to "Turn off",
the light is always off. If you do not want the light
to be off, set Light control to the "Darker" setting.
(Page 11)
The Cleanliness Monitor changes
color frequently.
• The Cleanliness Monitor automatically changes
color when the dust(sensitive) sensor and odor
sensor detect impurities. If you are concerned
about the change, you can change sensor
sensitivity. (Page 11)
The Main Unit's Display does not
match weather report.
• Outdoor and indoor as well as the home
environment (the volume of traffic nearby, number
of stories in home, etc.) may cause a reading
different than those data.
• There is a difference in the level within the same
room.
ERROR DISPLAY
• The concentration of
Plasmacluster ion is descending.
Maintain the Plasmacluster
Ion Generating Unit (electrode
section).
• Is the Plasmacluster Ion
Generating Unit inserted
properly?
Pull out the Plasmacluster Ion
Generating Unit and insert it to
the end again, and then carry
out the operation again.
• Unplug the Main Unit, wait one
minute, and then plug the Main
Unit in again.
12
2022/04/22
2022/04/22
11:05:42
11:05:42
Advertisement
