An exchange filter for the air purifier (16 pages)
Summary of Contents for Sharp FX-J80A
空氣清新機 使用說明書 “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. * The number in this technology mark indicates an * The number in this technology mark indicates an approximate number of ions supplied into air of 1...
ENGLISH Thank you for purchasing this SHARP Air Purifier. Please read this manual carefully before using the product. This manual should be kept in a safe place for handy reference. CONTENTS IMPORTANT SAFETY INSTRUCTIONS ..2 CARE AND MAINTENANCE / PARTS NAME ..........4 REPLACEMENT FILTER INSTALLATION ......6...
A unique Combination of Air Treatment Technologies Triple Filteration System + Plasmacluster High Density Plasmacluster 25000 The higher the PCI density is, the more effective PCI has. Triple Filteration System TRAP DUST Pre-Filter traps dust larger than approx 240 micron particles. DECREASES ODORS Active Carbon Deodorizing Filter absorbs many common household odors.
– What to do if the main unit be replaced by the manufacturer, its interferes with radio or TV reception service agent, a Sharp authorized Service Center or similarly qualified If the air purifier interferes with radio or persons in order to avoid a hazard.
CAUTIONS CONCERNING INSTALLATION GUIDELINES OPERATION • Avoid locations where the sensors are • Do not block the air intake or air outlet. exposed to direct wind. • Always operate the main unit in an Doing so can cause the main unit to upright position.
PARTS NAME MAIN UNIT (FRONT) 1. Operation Panel 2. Air Outlet (Front/Back) 3. Cleanliness Monitor 4. Front Display 5. Main Unit 6. Handle (2 Locations) 7. Front Louver 8. Pre-Filter (Back Panel) 9. Air Inlet 10. Active Carbon Deodorizing Filter 11.
OPERATION PANEL Touch the button with " " to start. FRONT DISPLAY 1. Power ON/OFF Button 12. Odor Indicator Light 2. AUTO Button, Indicator Light Indicates the Odor Sensor detects odors. TURN OFF Orange 3. CLEAN ION SHOWER Button, Clean Impure Indicator Light 13.
FILTER INSTALLATION Always be sure to remove the power plug from the wall outlet. HEPA FILTER / ACTIVE CARBON DEODORIZING FILTER Remove the Pre-Filter (Back Panel). Pre-Filter (Back Panel) Remove the plastic bag from the filter. Active Carbon HEPA Filter Deodorizing Filter Install the filters in the correct order as shown.
OPERATION PLASMACLUSTER ION START/STOP SPOT MODE START STOP Use this mode when you want to remove adhering ♪ ♪ ♪ ♪ ♪ ♪ ♪ ♪ odor, germs, and other substances from cloths, sofas and curtains. ♪ AUTO MODE Adjust Front Louver manually. The fan speed is automatically controlled depending on the 3 detection.
ON TIMER CHILD LOCK Select the length of time you want. The operation panel will be locked. The Main Unit automatically starts once the CANCELLATION selected time is passes. (with the Main Unit OFF) ♪ ♪ ♪ ♪ Front Display more than 3 sec.
MODE SETTINGS You can change the functions in the table "Type of setting" below. Turn the Main Unit power OFF. Select "Setting number". Reverse Forward ♪ ♪ ♪ more than 3 sec. Select "Function number". Reverse Forward ♪ ～ ♪ ♪...
CARE AND MAINTENANCE / REPLACEMENT HEPA FILTER / ACTIVE CARBON DEODORIZING FILTER FILTER MAINTENANCE INDICATOR LIFE OF FILTERS Filter life varies depending on the room environment, The filter maintenance Indicator Light usage conditions, and location of the Main Unit. will turn on after approximately Lifespan of HEPA filter and Active Carbon 720 hours operating.
MAIN UNIT / PRE-FILTER (BACK PANEL) How to clean hard to remove dirt. Wipe with a dry, soft cloth NOTE Pre-Filter 1. Add a small amount of neutral detergent to water and soak about 10 minutes. Pre-Filter CAUTION (Back Panel) Do not apply excessive pressure when scrubbing the pre-filter.
• Dirty or clogged sensitive dust sensor openings ERROR DISPLAY interfere with sensor operation. Gently clean the sensor filter or the back panel. If error occurs repeatedly, contact the Sharp The Main Unit makes a clicking or Service Center. ticking sound.
SPECIFICATIONS Model FX-J80A Power supply 220 V 50 Hz Fan Speed Adjustment HIGH Fan Speed (m /hour) Noise Level (dBA) Rated Power (W) Standby Power (W) Applicable Room Size (m ~ 62 High density Plasmacluster ion ~ 35 recommended room size (m...