Table of Contents
Advertisement
In order to use the drying function, set the drying
‒
function.
→ "Setting the drying process", Page 27
Setting the drying process
1.
Allow the appliance to cool down.
2.
Remove coarse dirt from the cooking compartment
and wipe away moisture from the cooking compart-
ment floor.
3.
Press
.
4.
In the operating mode menu, press the drying oper-
ating mode.
21 Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
21.1 Detaching the appliance door
WARNING ‒ Risk of injury!
Components inside the appliance door may have sharp
edges.
▶
Wear protective gloves.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
▶
Keep your hands away from the hinges.
1.
Open the appliance door fully.
2.
WARNING ‒ Risk of injury!
When the hinges are not secured, they can snap
shut with great force.
▶
Make sure that the locking levers are always
either fully closed or (when detaching the oven
door) fully open.
Open the locking levers on the left- and right-hand
hinges.
Locking levers opened
Locking levers closed
a The locking levers are open. The hinges are now se-
cured and cannot snap shut.
The hinge is now se-
cured and cannot snap
shut.
The appliance door is
secured and cannot be
detached.
The duration is set to 10:00 min. and cannot be
changed.
5.
Press
to start the drying function.
a The appliance starts to dry and the duration counts
down.
6.
Once the duration has elapsed:
A message appears in the display.
‒
Press
to silence the audible signal before
‒
it is due to end.
Press
to switch the appliance off.
‒
3.
Close the appliance door fully . Grab hold of the
appliance door with both hands (on the left and
right) and pull it upwards and out .
4.
Carefully place the appliance door on a level sur-
face.
Removing the condensate tray
Notes
¡ Wipe down the condensate tray after every steam
operation or before removing it.
¡ Do not clean the condensate tray in the dishwasher
Requirement: The appliance door must be removed.
1.
Press on the left-hand pressure surface
the hook is released.
2.
Press on the right-hand pressure surface
the hook is released.
3.
Tilt the condensate tray forwards slightly until the
lower retaining hooks are released.
4.
Use both hands to pull the condensate tray
wards and out at an angle
Appliance door en
until
until
up-
.
27
Advertisement
Table of Contents
