Table of Contents
Advertisement
7) BAT (BATTERY)
8) F_PANEL (2 x 10 pins Connector)
Please connect the power LED, PC speaker, reset switch and power switch etc of your chassisfront
panel to the F_PANEL connector according to the pin assignment below.
HD (IDE Hard Disk Active LED)
SPK (Speaker Connector)
RES (Reset Switch)
PW (Soft Power Connector)
MSG (Message LED/ Power/ Sleep LED)
NC
+
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
If you want to erase CMOS...
1. Turn OFF the computer and unplug the power cord.
2. Remove the battery, wait for 30 second.
3. Re-install the battery.
4. Plug the power cord and turn ON the computer.
Messa ge L ED /
Po we r /
Sl ee p LED
IDE H a rd D i sk Acti ve LED
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Open: Normal Operation
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
NC
- 15 -
Soft Po we r
Con nector
Sp eaker Co nne ctor
R eset Swi tch
Hardware Installation Process
Advertisement
Table of Contents
