Biostar BIPV10-IAP Setup Manual page 38

RTC Alarm Time
You can choose the system boot up time, input hour, minute and second to specify.
Resume On PME#
This item allows you to disable or enable PME to generate a wake event.
Options: Disabled (Default) / Enabled
Restore on AC Power Loss by IO
This setting specifies how your system should behave after a power fail or interrupts
occurs. By choosing Disabled will leave the computer in the power off state.
Choosing Enabled will restore the system to the status before power failure or
interrupt occurs.
Options: Power Off (Default) / Power ON / Last State
USB Configuration
This item shows the USB controller and using USB device information.
Advanced
USB Configuration
Module Version - 2.24.5-14.4
USB Devices Enabled:
Legacy USB Support
USB 2.0 Controller Mode
BIOS EHCI Hand-Off
> USB Mass Storage Device Configuration
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Legacy USB Support
This item determines if the BIOS should provide legacy support for USB devices
like the keyboard, mouse, and USB drive. This feature is useful for using USB
devices with operating systems that do not natively support USB (e.g. Microsoft
MS-DOS or Windows NT).
Options: Enabled (Default) / Disabled / Auto
BIOS SETUP UTILITY
[Enabled]
[HiSpeed]
[Enabled]
BIPV10-IAP
Enables support for
legacy USB. AUTO
option disables
legacy support if
no USB devices are
connected.
Select Screen
Select Item
Change Option
+-
F1 General Help
F10 Save and Exit
Exit
ESC
37