Makita DTW300RFJ Instruction Manual page 9

NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
Changing the application mode
This tool employs several easy-to-use application modes for driving bolts with good control.
The type of the application mode changes every time you press the button
NOTE: You can extend the time to change the application mode approximately one minute if you press the button
Application mode
(Assist type displayed on panel)
Bolt mode
Bolt mode (1)
Bolt mode (2)
Feature
Clockwise
This mode helps to repeat screwdriving
continuously with equal torque. This mode
also helps to reduce the risk of breakage
of bolts/nuts due to overtightening.
Counterclockwise
This mode helps to prevent a bolt from
falling off. When loosening a bolt with
the tool driving in counterclockwise
rotation, the tool automatically stops
or slows down after the bolt/nut gets
enough loosened.
NOTE:
The timing to stop the driving varies
depending on the type of the bolt/nut
and material to be driven. Make a test
driving before using this mode.
Clockwise
The tool stops automatically as soon as
it has started impact blows.
Counterclockwise
The impact force is 4. The tool stops
automatically as soon as it has loos-
ened the bolt/nut.
Clockwise
The tool stops automatically approx-
imately 0.5 second later from the
moment that the tool has started impact
blows.
Counterclockwise
The impact force is 4. The tool stops
automatically as soon as it has loos-
ened the bolt/nut.
9 ENGLISH
.
Purpose
Clockwise
Preventing over tightening of bolts.
Counterclockwise
Loosening bolts.
–
–
.
or .