Makita DTW300RFJ Instruction Manual page 10

Application mode
(Assist type displayed on panel)
Bolt mode (3)
: The lamp is on.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
Full speed mode
► 1 . Button 2. Lamp
When full speed mode is turned on, the tool speed
becomes fastest even if you do not pull the switch trig-
ger fully. When full speed mode is turned off, the tool
speed increases as you increase the pressure on the
switch trigger.
To turn on full speed mode, press and hold the but-
ton . To turn off full speed mode, press and hold the
button again.
The lamp turns on while full speed mode is on.
NOTE: Full speed mode continues even after switch-
ing the impact force mode/auto stop mode.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Selecting correct impact socket
Always use the correct size impact socket for bolts and
nuts. An incorrect size impact socket will result in inac-
curate and inconsistent fastening torque and/or damage
to the bolt or nut.
Clockwise
The tool stops automatically approxi-
mately 1 second later from the moment
that the tool has started impact blows.
Counterclockwise
The tool slows down the rotation after it
has loosened the bolt/nut.
2 1
Feature
Installing or removing impact socket
Optional accessory
CAUTION:
and the mounting portion are not damaged before
installing the impact socket.
CAUTION:
make sure that it is firmly secured. If it comes out,
do not use it.
NOTE: The way of impact socket installation varies
depending on the type of the square drive on the tool.
Tool with the ring spring
Model DTW300
For impact socket without O-ring and pin
► 1 . Impact socket 2. Square drive 3. Ring spring
Push the impact socket onto the square drive until it
locks into place.
To remove the impact socket, simply pull it off.
10 ENGLISH
Purpose
–
Make sure that the impact socket
After inserting the impact socket,
1
2
3
.