SPECIFICATIONS Model DTW450 Capacities Standard bolt M12 - M22 High tensile bolt M12 - M16 Square drive 12.7 mm No load speed (min 1,600 Impacts per minute 2,200 Max. fastening torque 440 N·m Overall length 266 mm Net weight 3.1 - 3.4 kg Rated voltage D.C.
Do not abuse the cord. Never use the cord for NOTE: The declared vibration total value(s) has been carrying, pulling or unplugging the power tool. measured in accordance with a standard test method Keep cord away from heat, oil, sharp edges and may be used for comparing one tool with another.
Page 4
Battery tool use and care Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. Use power tools only with specifically desig- nated battery packs. Use of any other battery packs may create a risk of injury and fire. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one...
CAUTION: DO NOT let comfort or familiarity Only use genuine Makita batteries. with product (gained from repeated use) replace strict Use of non-genuine Makita batteries, or batteries that adherence to safety rules for the subject product. have been altered, may result in the battery bursting causing fires, personal injury and damage. It will also MISUSE or failure to follow the safety rules stated in this void the Makita warranty for the Makita tool and charger.
Page 6
Indicating the remaining battery Switch action capacity Only for battery cartridges with the indicator ► 1 . Switch trigger CAUTION: ► 1 . Indicator lamps 2. Check button • Before inserting the battery cartridge into the Press the check button on the battery cartridge to indi- tool, always check to see that the switch trigger cate the remaining battery capacity. The indicator lamps actuates properly and returns to the "OFF" light up for a few seconds. position when released.
Page 7
For impact socket with O-ring and pin NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. • The light is provided with anti excessive discharge circuit. When the lamp does not light up even after the light switch is turned on, there is likely to be bat- tery power drop. Try to charge the battery cartridge.
Hook Standrad bolt CAUTION: After installing the hook, make sure (kgf cm) that it is screwed firmly. (3,060) (M20) (2,040) (M16) (1,020) (M12) ► 1 . Groove 2. Screw 3. Hook The hook is convenient for temporarily hanging the tool. Fastening time(S) This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw.
Makita replacement parts. The manner of holding the tool or the material of driving position to be fastened will affect the torque. OPTIONAL Operating the tool at low speed will cause a reduc- tion in the fastening torque.