Integrated Peripherals - Gigabyte 8I845GVM-RZ User Manual

CPU Hyper-Threading
Enabled Enables CPU Hyper Threading Feature. Please note that this feature is only working
for operating system with multi processors mode supported. (Default value)
Disabled Disables CPU Hyper Threading.
Init Display First
Select the first initation of monitor or display from AGP or PCI VGA card.
Onboard/AGP Set Init display first to AGP. (Default value)
PCI Set Init display first to PCI.
Graphics Memory Size
128MB Driver use selected sized of system memory for 3D texturing to increase
graphics performance. (Default value)
Disabled Disable this function.
Graphics Share Memory
8MB Share 8MB system memory preallocated for frame buffer. (Default value)
1MB Share 1MB system memory preallocated for frame buffer.

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
IDE1 Conductor Cable
IDE2 Conductor Cable
USB Controller
USB Keyboard Support
USB Mouse Support
AC97 Audio
*
Onboard H/W LAN
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
Game Port Address
Midi Port Address
Midi Port IRQ
: Move Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled Enable onboard 1st channel IDE port. (Default value)
Disabled Disable onboard 1st channel IDE port.
On-Chip Secondary PCI IDE
Enabled Enable onboard 2nd channel IDE port. (Default value)
Disabled Disable onboard 2nd channel IDE port.
IDE1 Conductor Cable
Auto Will be automatically detected by BIOS. (Default value)
ATA66/100 Set IDE1 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is compatible with ATA66/100).
"*" For 8I845GVM-RZ only.
8I845GVM-RZ Series Motherboard
Integrated Peripherals
[Enabled]
[Enabled]
[Auto]
[Auto]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
Half
[378/IRQ7]
[SPP]
3
[201]
[330]
[10]
+/-/PU/PD: Value F10: Save
F6: Fail-Save Default
- 26 -
Item Help
Menu Level
If a hard disk
controller card is
used, set at Disabled
[Enabled]
Enable onboard IDE
channel
[Disabled]
Disable onboard IDE
channel
ESC: Exit F1: General Help
F7: Optimized Defaults