Start-Up; Before Starting Up For The First Time; Connecting The Appliance To The Mains Supply; Operation - Gastro-Cool GCDC280 Instructions For Use Manual

7

Start-up

7.1 Before starting up for the first time
After transportation the appliance should be left to stand for at least
24 hours so that the refrigerant can collect in the compressor. Non-
observance of this may damage the compressor and so lead to the
appliance malfunctioning. In such a case the warranty becomes invalid.
Clean the interior of the refrigerator and all of the accessories to
be found here with commercially available, mild cleaning products.
WARnInG: Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
cAUTIon: Please take care that the bottom of appliance is not
completely covered by bottles in order that the condensation drain is
not disrupted. It is best to put the bottles on a shelf.
The shelf can withstand the maximum load 4.5 kg.

7.2 connecting the appliance to the mains supply

IMPoRTAnT
It is imperative that the appliance be earthed according to
the directions. For this purpose the plug of the connecting
cable is provided with the appropriate contact.
IMPoRTAnT
Call a specialist electrician if the plug does not fit into the
socket. Do not try to force the plug into the socket.
IMPoRTAnT
If you disconnect the appliance from the mains supply, or
if a power cut occurs: wait for 5 minutes before you restart
the appliance.
54
8

operation

8.1 Switching the appliance on

In order to switch on the appliance push the mains plug into the socket.

8.2 Setting the temperature

The temperature can be set from 0°C to 10°C.
At GCGD360 and GCDC400 it is set by the knob.
At GCDC280, GCDC800, GCDC1050, GCUC100, GCUC200 and GCUC300
it is set by pressing the following buttons:
1. Press „SET" button, the set temperature is displayed.
2. Press UP (warm) and DOWN (cold) button to set the new temperature.
3. Press „Set" again to save and exit the adjustment.
4. If no more button is pressed within 10 seconds the actual cooler
inside temperature will be displayed.
°C

Up

Down
noTE
Please note that the temperature will change depending on the
ambient temperature (installation site), the frequency of opening
the door and the fittings.
SET
55