Gigabyte G-MAX TA1 User Manual page 5

3. System equipment installation
¡½ ¡½
¡½ Unload case
¡½ ¡½
Step 1: Remove the screw from the bottom of the case.
Step 2: Grasp the handle on the panel and pull out the case.
¡½ ¡½
¡½ Installing hard drive
¡½ ¡½
Step 1: Fix the hard drive on the base with screws and connect the hard drive with the IDE
ribbon cable.
Screw stands (Attention! Install hard drive on top of the screw stands on the base.)
(Attention! Make sure that the red (fool-proof) wire on the ribbon cable should be connected to PIN 1 of the hard drive as shown below.)
Red (fool-proof) wire should be connected to PIN 1.
User's Manual
5
English