Troubleshooting For Wireless Lan Setup - Brother MFC-J5730DW Reference Manual

Troubleshooting for Wireless LAN setup

Wireless LAN Report Error Codes
If the Wireless LAN Report shows that the connection failed, check the error code on the printed
report and see the corresponding instructions in the table:
Error Code Problem and Recommended Solutions
TS-01 The wireless setting is not activated, change the wireless setting to ON.
If a network cable is connected to your machine, disconnect it and change the
wireless setting of your machine to ON.
TS-02 The wireless access point/router cannot be detected. Do one of the following:
• Unplug the power to your wireless access point/router, wait for 10 seconds,
and then plug it back in.
• If your WLAN access point/router is using MAC address filtering, confirm
that the MAC address of the Brother machine is allowed in the filter.
• Check that you are selecting the correct SSID (network name) and are
entering the correct network key.
TS-03 The wireless network and security setting you entered may be incorrect.
Reconfirm the wireless network settings.
If you do not know this information, ask your network administrator.
TS-04 Unsupported authentication/encryption method has been detected on your
wireless access point/router.
Your wireless access point/router is using an authentication/encryption method
that is not supported by the device. Check that you are selecting the correct
SSID (network name).
TS-05 The specified SSID and network key are incorrect.
Check that you are selecting the correct SSID (network name) and are
entering the correct network key.
TS-06 The specified wireless security information is incorrect.
Check the authentication/encryption method that you are selecting and make
sure you are entering the correct network key.
TS-07 The machine cannot detect a wireless access point/router that has WPS
enabled.
To configure your wireless settings using WPS, confirm that your wireless
access point/router supports WPS and try again.
TS-08 Two or more wireless access points that have WPS enabled are detected.
Try again after a few minutes to avoid interference from other access points.
27