Table of Contents
Advertisement
2 Select the framing mode for the time code
generator (only when the frame rate setting
is "60" or "30").
Set using [Main Menu] B [TC/UB] B [Drop
Frame].
(A P58 [ Drop Frame ] )
[Drop]:
0
Sets the run mode of the time code generator
to drop frame mode. Use this setting when
placing emphasis on the recording time.
[Non Drop]:
0
Sets the run mode of the time code generator
to non-drop frame mode. Use this setting
when placing emphasis on the number of
frames.
Memo :
Drop frame/non-drop frame mode
When [Main Menu] B [System] B [Record Set]
0
B [Record Format] B [Frame Rate] is set to
"60p", "60i", or "30p", the actual number of
frames per second is approximately 59.94
(29.97). However, the time code processing
standard is "60p", "60i", or "30p" frames. To
make up for the frame number discrepancy, the
drop frame mode (Drop) drops the 00 frame and
01 frame every minute except for minutes that
are multiples of 10. However, in the case of
"60p", the 00, 01, 02 and 03 frame are dropped.
The non-drop frame mode (Non Drop) does not
0
drop frames and ignores the discrepancy with
the actual time.
Setting Time Code
1 Select [Main Menu] B [TC/UB] B [TC
Preset] and press the Set button (Set).
(A P58 [ TC Preset ] )
The [TC Preset] screen appears.
.
Memo :
When [TC/UB] B [TC Generator] is set to
0
"Regen", the parameter is displayed as "Regen"
and cannot be selected.
(A P58 [ TC Generator ] )
2 Set the time code (hour, minute, second,
frame).
Use the cross-shaped button (HI) to place the
cursor at the item to set, then use the cross-
shaped button (JK) to change the values.
During drop frame
.
Memo :
Pressing the [SUB 2] button resets each digit to
0
"0" and moves the cursor to the hour digit (left).
3 Check the values and press the Set button
(Set).
The time code is set and the screen returns
0
to [TC/UB].
4 Press the [Back] button.
Returns to the normal screen.
Setting Time Code Generator
1
Cursor
During non-drop
frame
49
Advertisement
Table of Contents
