Gestetner DSm616 Network Manual page 101

AutoNet
Use the "autonet" command to con-
figure AutoNet settings.
❖ ❖ ❖ ❖ Display
The following command displays
the current AutoNet settings.
msh> autonet
❖ ❖ ❖ ❖ Configuration
You can configure the AutoNet
settings.
msh> autonet interface_name
[on|off]
Note
❒ Select [on] to enable AutoNet.
❒ Select [off] to disable AutoNet.
❖ ❖ ❖ ❖ Interface Priority Configuration
You can assign priorities govern-
ing which interface obtains Au-
toNet parameters.
m s h > a u t o n e t p r i o r i t y
interface_name
Note
❒ Priority assignment is useful
when connecting more than one
interface to the machine.
❒ If an interface is not selected, the
interface appears according to
the currently set priority, re-
gardless of multiple interface
connections.
Interface Interface to be config-
name ured
ether Ethernet interface
*1
wlan IEEE 802.11b interface
*2
ip1394 IEEE 1394 interface
*1
Available when
802.11b interface unit is installed.
*2
Available when the optional 1394
interface board is installed.
Changing the password
Use the " passwd" command to
change the remote maintenance pass-
word.
❒ Be sure not to forget or lose the
❒ The default password is "pass-
A A A A
B B B B
C C C C
D D D D
the optional
Remote Maintenance by telnet
Reference
For more information about
AutoNet, see p.98 "Using Au-
toNet".
Important
password.
Note
word".
Enter "passwd".
msh> passwd
Enter the current password.
Old password:
Enter the new password.
New password:
Note
❒ The password must consist of
three to eight alphanumeric
characters and symbols. Pass-
words are case-sensitive. For ex-
ample, "R" is different from "r".
❒ The password is the same as
that used in configuring the net-
work interface board with a
Web browser and that used in
NIB Setup Tool. If you change a
password from telnet, the other
passwords are also changed.
Enter the new password again.
Retype new password:
9
93