Whirlpool YWED92HEFC2 Installation Instructions Manual page 22

Reverse door swing: round-shaped door, curved glass – double handle
1.
Remove door from dryer
IMPORTANT: If the protective fi lm has not yet been
removed from the dryer, peel the fi lm from the dryer door
before proceeding.
Using a T25 screwdriver, remove the four screws securing
®
the door hinge to the dryer and lift up and out to remove
the door. Place the door on a soft towel or other non-scratch
surface. Reinstall the four screws in the holes.
2.
Move the door strike
Using a T25 screwdriver, remove the two screws securing
®
the door strike to the door frame of the dryer. Rotate the strike
180° and attach to the opposite side of dryer door frame
as shown.
22
3.
Remove inner door from outer door
Position the door with the inside of the door facing up.
Using a Phillips screwdriver, remove the 10 screws securing
the inner door to the outer door. Lift off the inner door and
set aside.
4.
Remove hinge and latch
Using a T25 screwdriver, remove the three screws securing
®
the latch plate and latch backing plate and the fi ve screws
holding the hinge assembly in place.
Latch
Hinge