Page 1
The Evaluation kit also consists of few passive components and connectors that should be soldered on the board. These components are not presoldered so as to provide flexibility to the user for changing ampli‐ fier configuration as per the users application. Figure 1: EK74 Circuit Configuration Diagram TP3-1 RFB1 49.9 K...
146510CJ BNC Connector, PC Mount 91735A190 Screw, Panhead, #8 X 0.25” 91249A126 4‐40 Thread Size, 1‐1/2” Long 94758A101 18‐9 Stainless Steel Flange Nut, 4‐40 2221 Standoff, HEX, #8X 2.00” 571‐0100 Banana Jacks 5001 Test Point, PC mini EK74 Rev A...
9. #8 hex standoffs are also provided with the kit. Install the #8 x 0.25” screws (91735A190), provided with the kit, from the component side. Attach the standoffs to these screws on the corners of the board. EK74 Rev A...
P12 and P10. Input and output waveforms can be checked on an Oscilloscope by connecting it to the test points mounted on the board. Begin the test with minimum values of input and supply voltages. Figure 4: EK74 Build EK74 Rev A...
Page 6
EK74 Figure 5 and 6 show the input, output and over current flag waveforms when a PA 165 is evaluated using the EK74 evaluation kit. The yellow waveform (channel 1) represents an input signal of 4V and cyan wave‐ P‐P...
Page 7
SUPPORT, AUTOMOTIVE SAFETY, SECURITY DEVICES, OR OTHER CRITICAL APPLICATIONS. PRODUCTS IN SUCH APPLICATIONS ARE UNDERSTOOD TO BE FULLY AT THE CUSTOMER OR THE CUSTOMER’S RISK. Apex Microtechnology, Apex and Apex Precision Power are trademarks of Apex Microtechnology, Inc. All other corporate names noted herein may be trademarks of their respective holders. EK74 Rev A...