11. Use M4 screws to mount the heatsink on the PCB. This ensures that the heatsink does not move. 12. Make sure that the heat tab is grounded. 13. Connect the external connections via the BNC connector and banana jacks. Hook up power supplies and signals as necessary. The amplifier is now ready for evaluation. EK66 Rev A...
Page 4
4. 15 X Cage Jacks 4. 15 X Cage Jacks 5. 2 X M4 Screws 5. 2 X M4 Screws 6. 4 X #8 Panhead Screws 6. 4 X #8 Panhead Screws 7. 4 X #8 Hex Standoffs EK66 Rev A...
Oscilloscope by connecting it to the test points mounted on the board. Begin the test with minimum values of input and supply voltages. Figure 4 shows a typical output waveform of the PA194 using the EK66 Evaluation Kit. The yellow wave‐ form is the input pulse signal to the amplifier, while the blue waveform shows the output waveform.
SUPPORT, AUTOMOTIVE SAFETY, SECURITY DEVICES, OR OTHER CRITICAL APPLICATIONS. PRODUCTS IN SUCH APPLICATIONS ARE UNDERSTOOD TO BE FULLY AT THE CUSTOMER OR THE CUSTOMER’S RISK. Apex Microtechnology, Apex and Apex Precision Power are trademarks of Apex Microtechnology, Inc. All other corporate names noted herein may be trademarks of their respective holders. EK66 Rev A...