Precautions For Use; Cautions When Transporting; Cautions When Installing - Panasonic PT-VX610 Operating Instructions Manual

Precautions for use

Cautions when transporting

f When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. Doing
so may damage the internal parts and result in malfunctions.
f Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.

Cautions when installing

rDo not set up the projector outdoors.
The projector is designed for indoor use only.
rDo not use under the following conditions.
f Places where vibration and impacts occur such as in a car or vehicle: Doing so may damage the internal parts
and result in malfunctions.
f Location close to sea or where corrosive gas may occur: the projector may fall due to corrosion. Also, failure to
do so may shorten the life of the components and result in malfunction.
f Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare
cases due to the heated air from the air exhaust port or the hot or cooled air. Make sure that the exhaust
from the projector or other equipment, or the air from the air conditioner does not blow toward the front of the
projector.
f Places with sharp temperature fluctuations such as near lights (studio lamps): Doing so may shorten the life of
the luminous lamp, or result in deformation of the outer case due to heat, which may cause malfunction. Make
sure to observe the operating temperature range of the projector.
f Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
rBe sure to ask a specialized technician or your dealer when installing the product to a
ceiling.
This requires an optional ceiling mount bracket. Be sure to use the Projector Mount Bracket together with the
ceiling mount bracket for high ceilings or low ceilings.
Model No.:
① ET-PKL100H (for high ceilings), ET-PKV400B (Projector Mount Bracket)
② ET-PKL100S (for low ceilings), ET-PKV400B (Projector Mount Bracket)
rFocus adjustment
The projection lens is thermally affected by the light from the light source, making the focus unstable in the period
just after switching on the power. It is recommended that the images are projected continuously for at least 30
minutes before the focus is adjusted.
rDo not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
rDo not use the projector in a location that the ambient temperature exceed 40 °C
(104 °F).
Using the projector in a location that the altitude is too high or the ambient temperature is too high may shorten
the life of the components or result in malfunctions.
The upper limit of the operating temperature of the projector varies depending on the altitudes of the operating
environment.
When using it at altitudes below 1 200 m (3 937') above sea level: 0 °C (32 °F) ~ 40 °C (104 °F)
When using it at altitudes between 1 200 m (3 937') and 2 700 m (8 858') above sea level: 0 °C (32 °F) ~ 30 °C
(86 °F)
rDo not tilt the projector or place it on its side.
Do not tilt the projector body more than approximately ±30 degrees longitudinally or ±15 degrees laterally. Over
tilting may result in shortening the life of the components.
16 - ENGLISH
Chapter 1 Preparation - Precautions for use