[Projector Setup] Menu; [Status]; [Computer2 Select]; [Projector Id] - Panasonic PT-VX610 Operating Instructions Manual

[PROJECTOR SETUP] menu

On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
[RUNTIME]
*1
[SERIAL NUMBER]
[VERSION]
*1 The following conversion is required to calculate the rough estimate for lamp unit replacement.
A × 1 + B × 5/6 + C × 5/7
f A : The luminous lamp runtime when [LAMP POWER] is set to [NORMAL]
f B : The luminous lamp runtime when [LAMP POWER] is set to [ECO1]
f C : The luminous lamp runtime when [LAMP POWER] is set to [ECO2]
Note
f For the network status, refer to the [NETWORK] menu → [NETWORK STATUS]. (
f The model number of the optional replacement lamp unit is subject to change without prior notice.

[COMPUTER2 SELECT]

Switch the input/output of the <COMPUTER 2 IN/1 OUT> terminal.
1) Press as to select [COMPUTER2 SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[COMPUTER2 IN]

[COMPUTER1 OUT]
Note
f When COMPUTER2 input is selected, [COMPUTER2 SELECT] cannot be set.
f You cannot switch to COMPUTER 2 input when [COMPUTER2 SELECT] is set to [COMPUTER1 OUT].
f When set to [COMPUTER1 OUT], the signal input to the <COMPUTER 1 IN> terminal is output from the <COMPUTER 2 IN / 1 OUT>
terminal regardless of the selected input.

[PROJECTOR ID]

The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press as to select [PROJECTOR ID].
2) Press the <ENTER> button.
f The [PROJECTOR ID] screen is displayed.
78 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
Æ
page 53) for the operation of the menu screen.
[NAME]
Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[PROJECTOR] Displays the actual usage time of projector.
Displays the model No. of the replacement lamp unit for this projector.
[ECO1]
[LAMP
(ET-LAV400)]
[ECO2]
[NORMAL]
[PROJECTOR] Displays the serial number of the projector.
[MAIN] Displays the main version of the firmware of the projector.
[SUB] Displays the sub version of the firmware of the projector.
Formula for lamp unit replacement time (rough estimate)
Select when <COMPUTER 2 IN/1 OUT> terminal is used as COMPUTER 2 input.
Select when the signal input from the <COMPUTER 1 IN> terminal is output from the
<COMPUTER 2 IN / 1 OUT> terminal.
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [ECO1].
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [ECO2].
Displays the luminous lamp runtime in actual time when [LAMP
POWER] is set to [NORMAL].
Æ
page 90)