Changing The Paper Size In Tray 2 - Gestetner 3222 Copy Reference Manual

Changing the Paper Size in
Tray 2
A
Carry out steps A-J described in
"Changing the Paper Size in Tray
1 or the Optional Paper Table"
P.103 "Changing the Paper Size in
Tray 1 or the Optional Paper Ta-
ble".
Note
If the size of paper you wish to
load is not shown on the scale,
slide the paper size selector to
the "p" mark then specify the
paper size and type.
B
Push the switch-over lever to the
left or right depending on the
type of paper you have loaded:
Standard Paper
A Push the switch-over lever to
the left.
Non-standard Paper
e.g. OHP transparencies, transpar-
ent paper, postcards etc.
A Push the switch-over lever to
the right.
Note
When you push the switch-
over lever to the right, you
cannot use the following
functions.
• Sort/Stack/Staple
• Duplex
C
Push the paper tray in until it
stops.
Setting the non-standard size paper
A
Press the 1 key to select the sec-
ond paper tray. Then press the {#}
key.
B
Press the [Pap.Size] key.
Changing the Paper Size
3
105