OpEraTINg INsTruCTIONs operating control panel operating By remote control fINIshINg glass door removal and installation placing glass media glass media emBer Bed assemBly removal WIrINg dIagram rEplaCEmENT parTs neFB24Hg overvieW neFB27Hg overvieW neFB29Hg overvieW TrOuBlEshOOTINg WarraNTy 10.0 sErVICE hIsTOry 11.0 NOTEs NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.
1.0 INTROduCTION WARNING • ThIs applIaNCE Is hOT WhEN OpEraTEd aNd CaN CausE sEVErE BurNs If CONTaCTEd. • do not operate appliance before reading and understanding operating instructions. Failure to operate appliance according to operating instructions could cause fi re or injury. •...
LISTING APPROvALS This appliance has been tested in model Number neFB24Hg neFB27Hg neFB29Hg accordance with the CSA Standards for fixed and location-dedicated description 24" electric 27" electric 29" electric electric room appliances in the United Fireplace Fireplace Fireplace States and Canada. If you need...
CATION: BLACK LETTERING ON SILVER BACKGROUND. MINIMUM FONT SIZE TO BE MINIMUM OF 8.5 PT (3.2mm) "Hot surFace" laBel ERALL SIZE: 6" x 3" (W385-2017) NUMBERS TO BE ASCENDING FROM NEFB24HG 019016 Hard Wiring DWG#: W385-2154 RATING PLATE NEFB24HG laBel...
2.0 LOCATING APPLIANCE WARNING duE TO HIGH TEmPERATuRES, THIS ELECTRIC APPLIANCE SHOuLd BE LOCATEd OuT OF TRAFFIC. kEEP COmBuSTIBLE mATERIALS SuCH AS FuRNITuRE, PILLOwS, BEddING, PAPERS, CLOTHES ANd CuRTAINS AT LEAST 36" FROm THE FRONT OF THE APPLIANCE. NEvER LOCATE THIS ELECTRIC APPLIANCE wHERE IT mAy FALL INTO A BATHTuB OR OTHER wATER CONTAINER.
3.0 INSTALLATION WARNING rIsK Of fIrE! ThE pOWEr COrd musT NOT BE pINChEd agaINsT a sharp EdgE. sECurE COrd TO aVOId TrIppINg Or sNaggINg TO rEduCE ThE rIsK Of fIrE, ElECTrIC shOCK Or pErsONal INJury. dO NOT ruN COrd uNdEr CarpETINg. dO NOT COVEr COrd WITh ThrOW rugs, ruNNErs Or ThE lIKE. arraNgE COrd aWay frOm TraffIC arEas aNd WhErE IT WIll NOT BE TrIppEd OVEr.
Select a location that is not prone to moisture and is located at least 36" (914mm) away from combustible materials such as curtain drapes, furniture, bedding, paper etc. fig. 2 fig. 1 FLOOR (Or mantel base thickness) Once the rough opening has been NEFB24HG NEFB27HG NEFB29HG prepared, and the power has been 9" (229mm) 10" (254mm) 10" (254mm) routed to the right side of the recess, the appliance may be installed.
3.3.1 HARd wIRING INSTALLATION WARNING TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLAINCE. HARd wIRING CONNECTION If it is necessary to hard wire this appliance, a qualified electrician must remove the cord connection, and wire the appliance directly to the household wiring.
(L1) BLACK BLACK WHITE MANTEL STEP 1: LIFT ÉTAPES 1: SOULEVER GREEN WHITE TABLETTE WIRE NUT GREEN NOTE: To aid with moving the appliance, leave enough wire so that the appliance can be removed APPLIANCE from the enclosure without disconnecting the power supply. If servicing, shut off power supply. APPAREIL STEP 2: INSERT ÉTAPES 2: INSÉREZ...
4.0 OPERATING INSTRuCTIONS Once the appliance has been plugged into a grounded electrical outlet or hard wired to a dedicated 120V power supply, it is ready to operate. ATTENTION: Ensure the house circuit breakers for the power supply are turned on. when initially connecting the appliance into a power source the unit will perform an LEd check.
OPERATING By REmOTE CONTROL WARNING TO AvOId dANGER OF SuFFOCATION kEEP THE PACkAGING BAG AwAy FROm BABIES ANd CHILdREN. dO NOT uSE IN CRIBS, BEd, CARRIAGES OR PLAy PENS. THIS BAG IS NOT A TOy. kNOT BEFORE THROwING AwAy. NOTE: when operating the remote control, it must be directed towards the front center of the appliance. The power button can be used to turn the appliance on/off.
5.0 FINISHING WARNING POwER SuPPLy SERvICE muST BE COmPLETEd PRIOR TO FINISHING TO AvOId RECONSTRuCTION. HEAT vENTS ANd AIR OPENINGS CANNOT BE COvEREd IN ANy CIRCumSTANCES. GLASS dOOR REmOvAL ANd INSTALLATION WARNING FACING ANd/OR FINISHING mATERIAL muST NOT INTERFERE wITH AIR FLOw THROuGH AIR OPENINGS, LOuvRES OPENINGS, OPERATION OF LOuvRES OR dOORS OR ACCESS FOR SERvICE.
GLASS mEdIA EmBER BEd ASSEmBLy REmOvAL Remove glass media from ember tray. Remove the 4 screws, as shown. Lift ember bed up from the appliance and remove. sCrEW sCrEW EmBEr * NEfB27hg IllusTraTEd W415-1662 / 05.17.16...
6.0 wIRING dIAGRAm WARNING TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLAINCE. TEMPERATURE SENSOR / CAPTEUR DE EMPÉRATURE MAIN PCB BOARD / CARTE DE CIRCUIT IMPRIMÉ DECORATION LIGHT (OPTIONAL) / DECORATION DE LUMIÈRE(OPTIONNEL) T-FUSE /...
7.0 REPLACEmENT PARTS Contact your dealer or the factory for questions concerning prices and WARNING policies on replacement parts. Normally all parts can be ordered through your Authorized dealer / distributor. FOR wARRANTy REPLACEmENT PARTS, A PHOTOCOPy OF THE FAILURE TO POSITION THE PARTS IN ACCORDANCE WITH THIS ORIGINAL INvOICE wILL BE REQuIREd TO HONOuR THE CLAIm.
NEFB24HG OvERvIEw NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to vacuum up any broken glass from inside the appliance before operation. W415-1662 / 05.17.16...
NEFB27HG OvERvIEw NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to vacuum up any broken glass from inside the appliance before operation. W415-1662 / 05.17.16...
NEFB29HG OvERvIEw NOTE: Care must be taken when removing and disposing of any broken glass or damaged components. Be sure to vacuum up any broken glass from inside the appliance before operation. W415-1662 / 05.17.16...
8.0 TROuBLESHOOTING AVERTISSEMENT TurN Off ThE applaINCE COmplETEly aNd lET COOl BEfOrE sErVICINg. ONly a QualIfIEd sErVICE pErsON shOuld sErVICE aNd rEpaIr ThIs ElECTrIC applIaNCE. AVERTISSEMENT sympTOm prOBlEm TEsT sOluTION Dim or no fl ame Flame brightness not see “operation” section. selected Inspect the LED by selecting different brightness settings and Flame leds are burnt out...
Page 22
SYMPTOM PROBLEM TEST SOLUTION led Flashing appliance has overheated and unplug power or turn off the circuit breaker, allow safety thermal switch has tripped appliance to cool for 15 minutes, then plug in or turn the circuit breaker on. power Failure appliance has returned to default re-program appliance to original settings.
NAPOLEON warrants its products against manufacturing defects to the original purchaser only. Registering your warranty is not necessary. Simply provide your proof of purchase along with the model and serial number to make a warranty claim. NAPOLEON reserves the right to have its representative inspect any product or part thereof prior to honouring any warranty claim.
Page 27
à proximité de cet appareil ou tout autre appareil. Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada / 103 Miller Drive, Crittenden, Kentucky , USA, 41030 Téléphone 705-721-1212 • Télécopieur 705-720-9081 • www.napoleonfoyers.com • hearth@napoleonproducts.com 10,00 $ 1.16F...
Need help?
Do you have a question about the NEFB24HG and is the answer not in the manual?
Questions and answers