Specifications - Monacor AV-3033CCD Mounting Instructions

release the locking screw (1) and retighten it after
adjusting.
4.4 Power supply
For power supply, a regulated power supply unit with
an output voltage of 12 V
output current is required:
AV-30...CCD: 300 mA
AV-3031COL: 400 mA
From the MONACOR range, the following units are
recommended:
PS-500ST for indoor use or
PS-12WP for outdoor use
1) In case of power supply units with variable output
voltage, set the voltage to 12 V.
2) Connect the power supply unit to the inline jack (4)
by means of a low-voltage plug 5.5/2.5 mm (out-
side/inside diameter). Always observe the correct
polarity: The positive pole must be at the inner
contact of the plug.
Important! The inline jack (4) is not weather-
proof. In case of outdoor connection, protect it
accordingly.
3) Connect the power supply unit to a mains socket
(230 V~/50 Hz) and switch it on, if required. Thus,
the camera is switched on.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
and the following constant
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®

5 Specifications

Approval No. . . . . . . . . . . BZT G750 817J
Transmission frequency: channel 1
Transmitting power: . . . . ≤ 25 mW (EIRP)
Antenna: . . . . . . . . . . . . . omnidirectional antenna
Range
in the open: . . . . . . . . up to 500 m
in buildings: . . . . . . . . up to 50 m
Video signal
Video standard: . . . . . CCIR
Colour standard: . . . . . PAL (AV-3031COL only)
Bandwidth: . . . . . . . . . 50 Hz – 5 MHz
Power supply
Operating voltage: . . . 12 V
Power consumption
AV-30...CCD: . . . . . . 300 mA
AV-3031COL: . . . . . . 400 mA
Protection class
of housing: . . . . . . . . . . . IP 65
Ambient temperature: . . . -10 °C to +55 °C
Dimensions without
antenna: . . . . . . . . . . . . . 93 x 93 x 195 mm
Weight: . . . . . . . . . . . . . . 1000 g
Subject to technical modification.
2.4145 GHz
channel 2 2.4285 GHz
channel 3 2.4425 GHz
channel 4 2.4565 GHz
channel 5 2.4705 GHz
9