Power Button Board - HP 17g Maintenance And Service Manual

Power button board

Description
Power button board
Power button board cable
Before removing the power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
7. Remove the fan/heat sink (see
8. Remove the display (see
To remove the power button board:
1. Disconnect the cable from the power button board (1).
2. Remove the Phillips PM2.0×2.0 screw (2) that secures the board to the computer.
3. Remove the power button board from the computer (3).
Reverse this procedure to install the power button board.
Battery on page 32).
Optical drive on page
Bottom cover on page
Heat sink assembly on page
Display assembly on page
34).
41).
59).
67).
Component replacement procedures
Spare part number
926529-001
926517-001
79