True TDB-24-48-1-G-1 Installation Manual page 16

TEMPERATURE
• Correct temperature is a key factor to consider in storing
and dispensing draft beer. Too cool or too warm may cause
flavor loss, off taste and dispensing problems.
Helpful Hints on Controlling Temperature
• Keep a thermometer handy
PRESSURE
Dispensing pressures differ according to:
• The type of draft dispensing system
• The length of draft dispensing line
• The actual product - some require more,
some require less
• The temperature of the product
• The pressurizing agent: air pressure,
CO 2 or special blended gases.
TAPPING
Do not agitate the kegs unnecessarily. If excessive agitation
occurs allow kegs to settle for 1 to 2 hours before tapping.
TDD-1 CO 2 KNOCK-OUT
This instruction is TRUE's
recommended procedure for installing a
remote CO 2 container.
REQUIRED TOOLS
• Pliers
• Power Drill
• Silicone Sealer
• Drill bit, 1/2"
STEP 1
Remove black knockout plug with a pair
of pliers.
NOTE:
Knockout plug for CO 2 line can be
locate in two different areas. View
diagram to locate these two areas.
14
INSTALLATION / OPERATION INSTRUCTIONS
STEP 2
Use drill and bit to bore hole straight
back through wall into compressor
compartment.
STEP 3
Snake CO 2 line through hole down
and around exiting behind rear castor
underneath rear grill.
STEP 4
Seal hole around CO 2 line with silicone
sealer to prevent cold air leakage.
............ www.truemfg.com ............
True Food Service Equipment, Inc.
• Monitor temperature of draft in your cooler
and at the tap
• Keep cooler door closed as much as possible
to avoid temperature fluctuation
• Regular maintenance of refrigeration equipment
is recommended
Helpful Hints On Maintaining The Correct Pressure:
• Know which pressurizing agent to
use on which product and why.
• Monitor your regulators to ensure
applied pressure remains constant.
• Keep equipment in good repair.
Prior to tapping the keg, ensure that all beer faucet in the
serving location are in the off position. Completely remove
the dust cover (identification cap) from the keg.
Knockout Plug
can be located at
either location.
14