TRUE FOOD SERVICE EQUIPMENT, INC. 2001 East Terra Lane • P.O. Box 970 • O’Fallon, Missouri 63366 (636)-240-2400 • FAX (636)272-2408 • INT’L FAX (636)272-7546 • (800)325-6152 Parts Department (800)424-TRUE • Parts Department FAX# (636)272-9471 TABLE OF CONTENTS Safety Information...
Page 2
True Food Service Equipment, Inc. True Food Service Equipment, Inc..www.truemfg.com ..www.truemfg.com ...
You have selected one of the finest commercial refrigeration units made. It is manufactured under strict quality controls with only the best quality materials available. Your TRUE cooler when properly maintained will give you many Use this appliance for its intended purpose as described in this Owner Manual.
Leave the shelves in place so that children may not easily climb inside. USE OF EXTENSION CORDS NEVER USE AN EXTENSION CORD! TRUE will not warranty any refrigerator that has been connected to an extension cord..www.truemfg.com ..www.truemfg.com ...
If you do not have the right outlet (North America Use Only!) NEMA plugs TRUE uses these types of plugs. have a certified electrician install the correct power source.
Before you start to install your Trueunit, carefully inspect it for freight damage. If damage is discovered, immediately file a claim with the delivery freight carrier. True is not responsible for damage incurred during shipment. • Contact True Technical Service for BTU requirements.
(100°F+, 38°C+), you may want to install an exhaust fan. Warning Warranty is void if ventilation is insufficient. B. Proper leveling of your True cooler is critical to operating success (for non-mobile models). Effective condensate removal and door operation will be effected by leveling.
Wire Gauge for 2% Voltage Drop in Supply Circuits 230 Volts Amps ... www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. Distance In Feet To Center of Load Distance In Feet To Center of Load...
True Food Service Equipment, Inc. True Food Service Equipment, Inc. INSTALLATION / OPERATION INSTRUCTIONS INSTALLATION / OPERATION INSTRUCTIONS SEALING CABINET TO FLOOR Step 1 - Position Cabinet Allow one inch between the wall and rear of the refrigerated Bar Equipment to assure proper ventilation.
... www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. True recommends that a sole use circuit be dedicated for the unit. WARNING Compressor warranties are void if compressor burns out due to low voltage.
True dealer or recommended service agent. D. Good air flow in your True unit is critical. Be careful to load product so that it neither presses against the back wall, nor comes within four inches of the evaporator housing.
• Draft beer products have a recommended shelf life. If you have questions regarding the shelf life of any of your draught products, please consult with ... www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. SHELF INSTALLATION Shelf Shelf...
True Food Service Equipment, Inc. True Food Service Equipment, Inc. INSTALLATION / OPERATION INSTRUCTIONS INSTALLATION / OPERATION INSTRUCTIONS TEMPERATURE • Correct temperature is a key factor to consider in storing and dispensing draft beer. Too cool or too warm may cause flavor loss, off taste and dispensing problems.
Traps in beer lines. Beer too warm in kegs or lines. Too much pressure..www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. pressures from your beer supplier. Creeping gauge causing too much pressure.
True Food Service Equipment, Inc. True Food Service Equipment, Inc. MAINTENANCE, CARE & CLEANING MAINTENANCE, CARE & CLEANING TEMPERATURE CONTROL ADJUSTMENT FOR HIGH ALTITUDE ONLY! TERMS: Cut-out - Temperature sensed by the controller that shuts the compressor off. Cut-in - Temperature sensed by the controller that turns the compressor on.
3. Tap gauge for accurate reading. 4. Open regulator shut-off "C" and draw beer..www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. GAS CYLINDER Decreasing Pressure 1. Close regulator shut-off "C".
Note: Use cleaners approved by your beer supplier and follow their instructions. If you are using the cleaning kit purchased from True follow these instructions: Exacting cleanliness should be constantly maintained in your dispenser so that your draught beer will be at its best when served.Although the...
Clean off accumulated dirt from condensing coil with a stiff bristle brush..www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. STEP 5 Lift cardboard cover above fan at plastic plugs and carefully clean condenser coil and fan blades.
5. When finished be sure to replace the louvered grill. The grill protects the condenser. 6. Reconnect the electrical power to the unit. If you have any questions, please call True Manufacturing at 636-240-2400 or 800-325-6152 and ask for the Service Department. Service Department Availability Monday-Friday 7:30 a.m. to 5:30p.m.
Oxygen helps maintain the passivity film on stainless steel. 7. Hydrochloric acid (muriatic acid) should never be used on stainless steel 8. Regularly restore/passivate stainless steel ... www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc.
Page 21
True Food Service Equipment, Inc. True Food Service Equipment, Inc. MAINTENANCE, CARE & CLEANING MAINTENANCE, CARE & CLEANING Stainless Steel Equipment Care and Cleaning Recommended cleaners for certain situations / environments of stainless steel A) Soap, ammonia and detergent medallion applied with a cloth or sponge can be used for routine cleaning.
... www.truemfg.com ..www.truemfg.com ... True Food Service Equipment, Inc. True Food Service Equipment, Inc. WARNING: When replacing a light bulb make sure power to the unit is either turned off or unplugged.
TRUE and upon proper installation and start-up in accordance with the instruction packet supplied with each TRUE unit. TRUE’s obligation under this warranty is limited to a period of one (1) year from the date of original installation or 15 months after shipment date from TRUE, whichever occurs first.
Need help?
Do you have a question about the TBB-2 and is the answer not in the manual?
Questions and answers