Adding Oil - Pulsar PG3500MR Operator's Manual

Adding / Checking Engine Oil (See fig 4)
• Place generator on a level surface.
•
Remove the crankcase dipstick to ensure you do not overfill the engine.
• Insert a funnel into the crankcase dipstick hold and carefully add 4-Cycle engine oil (SAE10W- 30) to empty reservoir
until oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
• Be sure to replace dipstick before attempting to start the engine.
• To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick without rethreading.
You must add oil before first operating this generator. Always check oil level before each
CAUTION!
operation.
DO NOT USE E15 OR E85 FUEL IN THIS UNIT. IT IS A VIOLATION OF FEDERAL LAW AND
WILL DAMAGE THE UNIT AND VOID YOUR WARRANTY.
Fig 4
ASSEMBLY
11
Fig 5