Shelving Installation/Operation & Light Switches - True GDM-7-S-LD Installation Manual

True Food Service Equipment, Inc.
SHELVING INSTALLATION / OPERATION &
LIGHT SWITCH LOCATION
SHELF & ORGANIZER INSTALLATION:
A. Hook shelf clips onto shelf standards. (see illustration).
B. Position all four shelf clips equal in distance from the floor for
flat shelves.
C. Lower front of gravity feed TrueTrac organizers to enable proper
feed.
WIRE SHELVES:
Wire shelves are oriented so that cross support bars are facing down.
NOTE
GDM-5 models include an airflow guard on the rear of shelves to
maintain an air space at the rear of the cabinet. (see illustration).
TrueTrac ORGANIZERS:
TrueTrac organizers for Glass Door Merchandisers come with a
package of shelf retainer clips. Install clip on the side to the rear of
organizer (see illustration) to end of organizer that rests against left
or right outside wall.
With correct installation, the retainer clip should separate the rear of
the organizer from the rear interior wall of the cabinet.
NOTE
No retainer clips needed on center
organizers of a GDM-69.
Place shelves or organizers on shelf clips making sure all corners are
seated properly.
WARNING
Do not use pliers or any crimping
tools when installing shelf clips.
Altering shelf clips in any way can
lead to shelving instability.
LIGHT SWITCH LOCATION:
Light switch location depends upon the GDM model. Most GDM models will have the light switch located on the right side of the ceiling
inside the unit. Most instances the switch is located next to the temperature control. GDM-49's and 72's have the switch located on the right
side of the evaporator housing along the interior ceiling. GDM-9's, 5's, and GDM-5PT's have the switch located on the left side of the ceiling.
Some convenience store GDM's have the switch located behind the sliding doors above the light bulb for example the GDM-33SSL-54 and
the GDM-33CPT-54. G4SM-23 models have an additional switch for the rotating display shelves. The switch for the rotating shelves in the
G4SM-23 models is located under the sign frame.
23
INSTALLATION / OPERATION INSTRUCTIONS
Step 1
Step 2
Install the top tab of the shelf
clip into the proper hole.
Push up on the bottom of the
clip. Bottom tab of the shelf
clip will fit tightly. You may
need to squeeze or twist the
bottom of the shelf
clip to install.
............ www.truemfg.com ............
Shelf Installation Tips
1
. Install all the shelf clips before installing the shelves.
2
. Start at the bottom in terms of shelf installation and work your
way up.
3
. Always lay the back of each shelf down on the rear clips before the
front.
INSTALLING
SHELVES
(GDM-30 ONLY)
Tape door handles
back to the cabinet
when installing shelves
23