Startup - True GDM-7-S-LD Installation Manual

STARTUP

A. The compressor is ready to operate. Plug in the cooler.
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 35°F. Allow
unit to function several hours, completely cooling cabinet
before changing the control setting.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your
TRUE dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful
to load product so that it neither presses against the back
wall, nor comes within four inches of the evaporator
housing. Refrigerated air off the coil must circulate down
the back wall.
SLIDE DOOR OPERATION
When installing unit, loading product or rearranging shelving,
the slide doors must be propped open with the door latch.
The door latch is located on the inside wall of the unit. (See
image 1).
If the door must be removed open it to full extension and
then lift the door latch. Then lift the door up and out of the
bottom track and then out of the top door frame. (See image
2). Unhook the door cord from the top of the door. (See
image 3). Set the door to the side with the bottom rollers
facing up. Never set the slide door on it's rollers. Resting door
on rollers can cause damage and the door will not operate
correctly when opening and closing. To reinstall door do the
steps in reverse order.
12
INSTALLATION / OPERATION INSTRUCTIONS
............ www.truemfg.com ............
True Food Service Equipment, Inc.
NOTE
If the cooler is disconnected or shut off, wait five minutes before
starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE unit
empty for two to three days. This allows you to be sure electrical
wiring and installation are correct and no shipping damage
has occurred. Remember, our factory warranty does not cover
product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your
cooler. If at any time during the life of your cooler, a part is
needed, you may obtain this part by furnishing the model number
and serial number to the company from whom you purchased
the cooler. Call Toll-Free: (800)-424-TRUE (Direct to Parts
Department). (800)-325-6152 (U.S.A. & Canada only) or call:
(636)-240-2400.
1
2
3
12