Related Manuals for Turbo Air TGF-23FB
Summary of Contents for Turbo Air TGF-23FB
- Page 1 Turbo Air Speeds up the Pace of Innovation Glass Door Freezers Installation and Operation Manual Please read this manual completely before attempting to install or operate this equipment FREEZERS TGF-23F(B) TGF-49FE(B) TGF-72F(B) www.turboairinc.com...
- Page 2 CONTENTS PAGE 1. SPECIFICATIONS ..................2 2. SERIAL NUMBER ..................2 3. INSTALLATION .................... 3 4. CLEANING & CAUTION ................4 5. BASIC OPERATION ................5~9 6. TROUBLESHOOTING ................10 7. WARRANTY ..................11~13 SPECIFICATIONS Freezers CRATED MODEL COMP H.P V/Hz REFRIGERAN AMPS...
- Page 3 - Be sure that there is ample air space so that air can flow through the rear of the unit - Turbo Air recommends that the rear of the unit be no less than 5 inches from the wall 2. PLACE ON STRONG GROUND...
- Page 4 CLEANING 1. CLEANING THE INTERIOR AND EXTERIOR - The interior and exterior of the unit can be cleaned using warm water with soap - Do not use an abrasive cleaner because it will scratch the surface 2. CLEANING THE CONDENSER FINS - To maintain proper refrigeration performace, the Condenser coil must be free of dust, dirt, and grease This will require periodic cleaning.
- Page 5 BASIC OPERATION 1. Plug in and turn on the power and lamp switch located on the top of the bottom grille right side. The Display panel will be lighted and make a beep sound. The compressor will begin to run. After turning on the power, the fluorescent lamp will come on in a few minutes.
- Page 6 DISPLAY PANEL OF FREEZER (TGF-23F) TEMP CONTROL BUTTON (SEE PAGE 8) LAMP SWITCH INTERIOR TEMP INDICATOR (SEE PAGE 9) POWER SWITCH TEMPERATURE Turbo air T.F. DOOR TURBO FREEZE TURBO FREEZE DOOR OPENING FAN RUNNING TURBO FREEZE BUTTON (SEE PAGE 8)
- Page 7 DISPLAY PANEL OF FREEZER (TGF-49FE, TGF-72F) TEMP CONTROL BUTTON (SEE PAGE 8) LAMP SWITCH INTERIOR TEMP INDICATOR (SEE PAGE 9) POWER SWITCH LAMP POWER TEMPERATURE T.F. DOOR TURBO FREEZE TURBO FREEZE DOOR OPENING FAN RUNNING TURBO FREEZE BUTTON (SEE PAGE 8)
- Page 8 TURBO FREEZE 1. If you push the T.F. (Turbo Freeze) button, the compressor will run for 120 minutes to bring down the temperature more quickly. 2. If you push the T.F. button again during Turbo Freeze mode, the compressor will return to the normal operation.
- Page 9 INNER TEMPERATURE DISPLAY 1. It displays inside temperature. 2. Display range is -50˚F to 50˚F (-45˚C ~ +10˚C). 3. When inside temperature is lower than -50˚F, the panel will display ʻ ʼ. and, higher than +50˚F, the panel will show ʻ ʼ.
- Page 10 TROUBLESHOOTING SYMPTOMS CAUSES SOLUTIONS Freezer is melting • The setting temperature is too • Push the temperature down food high to contain food fresh. button for lower temperatures. The unit does not • There is a power connection • Check the power cord and plug in refrigerate at all failure problem.
- Page 11 TWO YEAR WARRANTY Turbo Air warrants to the original purchaser of every new Turbo Air refrigerated unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, under normal use and service, for a period of two (2) year from the date of original installation or 27 months after shipment date from Turbo Air , whichever occurs first.
- Page 12 3. ALTERATION, NEGLECT, ABUSE, MISUSE, ACCIDENT, DAMAGE DURING TRANSIT OR INSTALLATION, FIRE, FLOOD, ACTS OF GOD. TURBO AIR is not responsible for the repair or replacement of any parts that Turbo Air determines have been subjected after the date of manufacture to alteration, neglect, abuse, misuse, accident, damage during transit or installation, fire, flood, or an Act of God.
- Page 13 (2) year from the date of original installation or 27 months after shipment date from Turbo Air, whichever occurs first. Any part, covered under this warranty, that are by Turbo Air to have been defective within two (2) year of original installation or twenty seven (27) months after shipment date from manufacturer, whichever occurs first, is limited to the repair or replacement, including labor charges, of defective parts or assemblies.