Table of Contents
Advertisement
head at a time by following the
steps below.
1
Open the shaving head holder
(Fig. 14).
2 To unlock the retaining frame,
gently squeeze both sides of the
retaining frame and flip open
the frame (Fig. 17).
3 Remove the shaving head. Each
shaving head consists of a cutter
and a guard (Fig. 18).
Note: Do not clean more than
one cutter and guard at a time,
since they are all matching sets.
If you accidentally mix up the
cutters and guards, it may take
several weeks before optimal
shaving performance is restored.
4 Remove the cutter from the
shaving guard (Fig. 19).
5 Rinse both parts with water.
6 After cleaning, place the cutter
back into the guard with the
cutter legs pointing downwards
(Fig. 20).
7 Put the shaving head back into
the shaving head holder (Fig. 21).
Note: Make sure that the
shaving heads with the
projections fit exactly onto the
hooks of the shaving head
holder when placing them (Fig.
23). The shaving heads supplied
with this appliance either have
notches or projections. Both
shaving systems are the same.
8 Push the retaining frame back
onto the shaving head holder
until you hear a click (Fig. 22).
9 Close the shaving head holder
(Fig. 16).
Replacement
Replacing the shaving heads
For maximum shaving performance,
we advise you to replace the
shaving heads every two years.
Replace damaged shaving heads
immediately. Always replace the
shaving heads with original Philips
shaving heads (see 'Ordering
accessories').
1
Switch off the appliance.
2 Open the shaving unit by
opening both shaving head
holders (Fig. 14).
3 To unlock the retaining frames,
gently squeeze both sides of the
retaining frames and flip open
the shaving heads (Fig. 17).
4 Remove the shaving heads from
the shaving head holders (Fig.
18).
Throw away the used shaving
heads immediately to avoid
mixing them with the new
shaving heads.
5 Place the new shaving heads in
the shaving head holders.
Note: Make sure that the
shaving heads with the
projections fit exactly onto the
hooks of the shaving head
holder when placing them (Fig.
23). The shaving heads supplied
with this appliance either have
notches or projections. Both
shaving systems are the same.
6 Push the retaining frames back
onto the shaving head holder
until you hear a click (Fig. 22).
7 Close the shaving head holders
(Fig. 16).
Storage
Always slide the protection cap
onto the shaving unit to protect the
shaving unit from dirt or damage
during traveling or storage (Fig. 24).
We advise you to let the appliance
dry before you store it.
Ordering accessories
To buy accessories or spare parts,
visit www.philips.com/parts-and-
accessories or go to your Philips
dealer. You can also contact the
Philips Consumer Care Center in
your country (see the international
warranty leaflet for contact details).
Available parts
The following accessories and
spare parts are available:
- SH30 Philips shaving heads
- RQ575 Philips cleansing brush
attachment
- RQ563 Philips cleansing brush
attachment 3-pack
- HQ110 Cleaning spray
- HQ8505 supply unit
Note: Availability of the accessories
may differ by country.
Advertisement
Table of Contents
