Removing The Rechargeable Battery; Troubleshooting - Philips S566 Manual

Recycling
- Do not throw away the product
with the normal household
waste at the end of its life, but
hand it in at an official collection
point for recycling. By doing this,
you help to preserve the
environment.
- This product contains a built-in
rechargeable battery which shall
not be disposed of with normal
household waste. Please take
your product to an official
collection point or a Philips
service center to have a
professional remove the
rechargeable battery.
- Follow your country's rules for
the separate collection of
electrical and electronic
products and rechargeable
batteries. Correct disposal helps
prevent negative consequences
for the environment and human
health.
Removing the
rechargeable battery
Only remove the rechargeable
battery when you discard the
shaver. Before you remove the
battery, make sure that the
shaver is disconnected from the
mains and that the battery is
completely empty.
Take any necessary safety
precautions when you handle
tools to open the shaver.
Be careful, the battery strips are
sharp.
1 Disconnect the appliance from
the wall socket and let the
appliance run until the motor
stops.
2 Insert a screwdriver under the
edge of the upper front panel
and remove it (Fig. 25).
3 Undo the screws in the top part
of the shaver (Fig. 26).
4 Remove the cover (Fig. 27).
5 Insert a screwdriver under the
edge of the lower front panel to
remove it (Fig. 28).
6 Remove the inner panel with a
screwdriver (Fig. 29).
7 Push the inner frame out of the
housing with the screwdriver
(Fig. 30).
8 Cut the wires from the motor
with pliers (Fig. 31) and remove
the printed circuit board (Fig. 32).
9 Break the battery tags and
remove the batteries (Fig. 33).

Troubleshooting

This chapter summarizes the most
common problems you could
encounter with the appliance. If you
are unable to solve the problem
with the information below, visit
www.philips.com/support for a list
of frequently asked questions or
contact the Consumer Care Center
in your country.
Prob
lem
The
shaver
does
not
work as
well as
it used
to.
The
shaver
does
not
work
when I
switch it
on.
Possible
cause
The
shaving
heads
are
dam
aged or
worn.
The
shaving
heads
are dirty.
Long
hairs
obstruct
the
shaving
heads.
The
recharge
able
battery is
low.
The
recharge
able
battery is
empty.
Solution
Replace the
shaving
heads (see
'Replace
ment').
Clean the
shaving
heads (see
'Cleaning
and
maintenance
').
Clean the
shaving
heads (see
'Cleaning
and
maintenance
').
Switch off
the shaver
and recharge
the battery
(see
'Charging').
Switch off
the shaver
and recharge
the battery
(see
'Charging').