Electromagnetic Fields (Emf); Charging With The Supply Unit - Philips S566 Manual

- Water may drip from the bottom
of the shaver when you rinse it.
This is normal and not
dangerous because all
electronics are enclosed in a
sealed power unit inside the
shaver.
- Do not use the supply unit in or
near wall sockets that contain
an electric air freshener to
prevent irreparable damage to
the supply unit.

Electromagnetic fields (EMF)

This Philips appliance complies
with all applicable standards and
regulations regarding exposure to
electromagnetic fields.
General
- This shaver is waterproof (Fig. 3).
It is suitable for use in the bath
or shower and for cleaning
under the tap. For safety
reasons, the shaver can
therefore only be used without
cord.
- The supply unit is suitable for
mains voltages ranging from 100
to 240 volts.
- The supply unit transforms
100-240 volts to a safe low
voltage of less than 24 volts.
Charging
Note: This appliance can only be
used without cord.
Charge the appliance before first
use and when the display indicates
that the battery is almost empty.
Charging takes approx. 1 hour. A
fully charged shaver provides up to
45 minutes of shaving time.

Charging with the supply unit

1 Make sure the shaver is
switched off.
2 Put the small plug in the shaver
and put the supply unit in the
wall socket.
The display of the shaver
indicates that the shaver is
charging.
3 After charging, remove the
supply unit from the wall socket
and pull the small plug out of
the appliance.
Charge indications
Battery low
S586: When the battery is almost
empty, the bottom light of the
battery charge indicator flashes
orange (Fig. 5).
S566: When the battery is almost
empty, the battery charge indicator
flashes orange.
Battery charging
S586: When the appliance is
charging, the bottom light of the
battery charge indicator first flashes
and then lights up continuously
(Fig. 6). After this the second light
flashes and then lights up
continuously, and so on until the
appliance is fully charged.
S566: When the appliance is
charging, the battery charge
indicator flashes white.
Battery full
S586: When the battery is fully
charged, all lights of the battery
charge indicator light up white
continuously (Fig. 7).
S566: When the battery is fully
charged, the battery charge
indicator lights up white
continuously.
Note: This appliance can only be
used without cord.
'Unplug before use' reminder
S586: All lights of the battery
charge indicator flash 3 times to
remind you to unplug the shaver
first.
S566: The battery charge indicator
flashes fast briefly to remind you to
unplug the shaver first.
Using the appliance
Removing or attaching the
click-on attachments
1 Make sure the appliance is
switched off.
2 Insert the lug of the attachment
into the slot in the top of the
appliance. Then press down the
attachment to attach it to the
appliance ('click') (Fig. 8).
3 Pull the attachment straight off
the appliance (Fig. 9).
Note: Do not twist the
attachment while you pull it off
the appliance.