Hitachi CP-X3014WN User Manual page 20

3. Web Control
3.1 Projector Web Control - Network Settings (continued)
Item
Wireless Setup
Mode
IP Configuration
DHCP ON
DHCP OFF
IP Address
Subnet Mask
Default
Gateway
DNS Server Address
Ch
Encryption
WEP Key
WPA Passphrase
SSID
(continued on next page)
20
Configures the wireless LAN settings.
Select "AD-HOC" or "Infrastructure".
Configures network settings.
Enables DHCP.
Disables DHCP.
Configures the IP address when DHCP is disabled.
Configures the subnet mask when DHCP is disabled.
Configures the default gateway when DHCP is disabled.
Configures the DNS server address.
Select from "1" to "11" a channel to use in the AD-HOC mode.
NOTE
• Depending on the country where you are
the channels may vary. In addition, depending on the
country or region where you are may be required to use a
wireless network card that confirm to the standards in the
respective country or region.
Select data encryption method.
Input the WEP key.
Either ASCII characters or hexadecimal numbers can be
used during WEP key input. The length of the key is defined
as follows according to the WEP and character formats.
Encryption
WEP 64bit
WEP 128bit
Input WPA Passphrase.
Available number of input characters is 8 to 63. Only
alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@ [\]^_`{|}~ and space
Select an SSID from the list.
If you require to set your unique SSID, select [Custom], then
set your own SSID following the rules below.
Maximum number of input characters is 32.
Only alphabets, numbers and following symbols can be used.
!"#$%&'()*+,-./:;<=>?@[\]^_`{|}~ and space.
Description
ASCII characters
5 characters
13 characters
HEX numbers
10 characters
26 characters