Hitachi CP-X3014WN User Manual page 13

1.4 Manual network connection setting - Wireless LAN - (continued)
4) Select "Use the following IP address" and configure the IP
address, Subnet mask and Default gateway for the computer
accordingly.
After setting is complete, click [OK] to close the window.
[About IP address]
The Network address portion of the IP address setting on your computer must
be the same as the setting on the projector. Also, the entire IP address on the
computer must not overlap with that of the other devices on the same network,
including the projector.
For example
The projector's settings are as follows.
Therefore, specify the computer's IP address as follows.
Select from 1 to 254 for "xxx" not duplicating with any other equipments.
In this case, since the IP address of the projector is "192.168.10.254", specify
a setting between 1 to 253 for the computer.
NOTE
• "0.0.0.0" cannot be set to the IP address.
• The projector's IP address can be changed by using the configuration utility
via a web browser. (&20)
• If the projector and the computer exist in the same network (i.e. same network
address), you can leave the default gateway field blank.
• When the projector and the computer exist in different networks, the default
gateway must be set. Consult to the network administrator in detail.
(continued on next page)
IP address: 192.168.10.254
Subnet mask: 255.255.255.0
(Network address: 192.168.10 in this case)
IP address: 192.168.10.xxx (xxx shows decimal number.)
Subnet mask: 255.255.255.0
(Network address: 192.168.10 in this case)
1. Connection to the network
13