Do not throw away the slot cover. For cooling, protection against fire and in order to
comply with EMC regulations, you must refit the slot cover if you remove the board.
► Push the board into the slot (1).
► Tighten the screw on the slot cover (2).
► Secure the cover plate on the casing again.
► If necessary, connect the cables to the board.
► Close the casing (see
If you have installed or removed a board, please check the relevant PCI
slot settings in the BIOS Setup. If necessary, change the settings. Further
information is provided in the PCI board documentation.
Board removing
► Open the casing (see
Board,
► Remove the cover plate (see
► Disconnect the cables connected to the board.
Fujitsu
2
1
"Closing the casing", Page
"Opening the casing", Page
"Board installing", Page
31).
30).
38).
System expansions
39