Troubleshooting - Toro 60213 60216 Operator's Manual

Troubleshooting

Problem
The engine does not start.
The engine lacks power or runs rough.
The belt slips or comes off the pulleys.
The paddles rotate when the clutch lever
is in the O position.
FF
The paddles do not rotate when the clutch
lever is in the O position.
N
The paddles rotate slowly when the clutch
lever is in the O position.
N
Possible Cause
1. The fuel-valve lever is in the O
position.
2. The choke is closed
3. The choke is open.
4. The engine On/Off switch is in the O
position.
5. The engine oil level is low (engines
with the oil-level switch).
6. The fuel tank is empty.
7. The engine contains bad/old fuel.
8. The spark plug is fouled or improperly
gapped.
9. The spark plug is wet with fuel (flooded
engine).
10. The spark-plug wire is loose or
disconnected.
1. The air filter is restricted.
2. The engine contains bad or old fuel.
3. There is water or contamination in the
fuel.
4. The fuel line is restricted.
5. The choke is closed
6. The spark plug is worn or has buildup
on the electrodes.
7. There is too much oil in the engine
crankcase.
1. The belt tension is insufficient.
2. The belt is worn.
3. The pulley(s) are worn.
4. The pulley(s) are misaligned.
1. The clutch lever is not adjusted
correctly.
2. The belt guide is not adjusted correctly.
1. The clutch lever is not adjusted
correctly.
2. The paddles are stuck in the drum
1. The clutch lever is not adjusted
correctly.
50
Corrective Action
1. Move the fuel-valve lever to the O
FF
position.
2. Open the choke when starting a hot
engine.
3. Close the choke when starting a cold
engine.
4. Rotate the switch to the O
FF
5. Fill the engine, with the recommended
oil, to the proper level.
6. Fill the fuel tank with fresh fuel.
7. Drain the fuel tank and carburetor.
Refuel with fresh fuel.
8. Gap or replace the spark plug.
9. Remove the spark plug, dry it, and
install the plug. Start the engine with
the throttle in the M
10. Remove the spark-plug wire, clean the
spark-plug terminal and the terminal
socket in the boot of the spark-plug
wire, and install the spark-plug wire.
1. Clean or replace the air-filter
element(s).
2. Drain the fuel tank and carburetor.
Refuel with fresh fuel.
3. Drain the fuel tank and carburetor.
Refuel with fresh fuel.
4. Clean the fuel filter and sediment cup.
5. Open the choke.
6. Check the electrode gap and adjust or
replace the spark plug.
7. Drain the oil to the proper level.
1. Adjust the belt tension.
2. Replace the belt.
3. Contact your Authorized Service
Dealer.
4. Align the pulley(s).
1. Adjust the belt tension.
2. Adjust the belt guide.
1. Adjust the belt tension.
2. Clean the paddles and drum.
1. Adjust the belt tension.
N
position.
N
position.
AX